2007 Chevrolet Matiz

Front Brake pipe excessively corroded to rear (1.1.11 (c))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Front Seat belt anchorage prescribed area strength or continuity significantly reduced (7.1.1 (a) (i))

Nearside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced (7.1.1 (a) (i))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front Wheel bearing has slight play (5.1.3 (a) (i))

Nearside Rear Shock absorbers has a reduced damping effect (5.3.2 (d))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Shock absorbers has a reduced damping effect (5.3.2 (d))

Nearside Headlamp lens slightly defective (4.1.1 (b) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))

Offside Headlamp lens slightly defective (4.1.1 (b) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))

Front Brake pipe corroded, covered in grease or other material Both (1.1.11 (c))

Handbrake slightly travel reserve

Nearside Front Tyre over ten years old fitted to a rear axle of a bus (5.2.3 (m))

Nearside Front Tyre slightly damaged (5.2.3 (d) (ii))

Rear Brake pipe corroded, covered in grease or other material Both (1.1.11 (c))

Front Brake pipe corroded, covered in grease or other material Both (1.1.11 (c))

Handbrake slightly travel reserve

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Front Tyre over ten years old fitted to a rear axle of a bus (5.2.3 (m))

Nearside Front Tyre slightly damaged (5.2.3 (d) (ii))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Rear Brake pipe corroded, covered in grease or other material Both (1.1.11 (c))

Nearside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Brake pipe excessively corroded Both rear to flexi hoses (1.1.11 (c))

Emissions not tested (8.2.1.2 (d))

Nearside Front Headlamp aim too low (4.1.2 (a))

Nearside Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Nearside Rear Brake pipe excessively corroded to cylinder (1.1.11 (c))

Nearside Rear Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Rear Exhaust has a major leak of exhaust gases (6.1.2 (a))

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Nearside Rear wheel bearing has excessive play (2.6.2)

Nearside Registration plate lamp not working (1.1.C.1d)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Rear wheel bearing has excessive play (2.6.2)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Bonnet cannot be secured in the closed position (8.4.1)

Nearside Front position lamp(s) not working (1.1.A.3b)

Offside Front position lamp(s) not working (1.1.A.3b)

brake pipes coated in grease

Front Brakes imbalanced across an axle (3.7.B.5b)

Nearside rear brake binding (3.7.B.1)

Nearside rear brake recording little or no effort (3.7.B.5a)

Rear Brakes imbalanced across an axle Axle 2 (3.7.B.5b)

brake pipes coated in grease

Brakes imbalanced across an axle (3.7.B.5b)

Nearside Headlamp not working on dipped beam (1.7.5a)

Offside rear brake recording little or no effort (3.7.B.5a)

Centre Exhaust system not adequately supported (7.1.1)

Windscreen washer provides insufficient washer liquid (8.2.3)

Windscreen wiper does not clear the windscreen effectively (8.2.2)

Anti-lock braking system warning lamp indicates an ABS fault (3.4.1c)

Brake pedal anti-slip provision missing (3.3.A.1b)

Nearside Headlamp not working on dipped beam (1.7.5a)

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)