1971 Volkswagen Beetle

Front Anti-roll bar pin or bush worn but not resulting in excessive movement both nearside and offside have wear (5.3.4 (a) (i))

Nearside Rear Inner misting of oil on inner brake drum shield not effecting braking performance

EXHAUSAT BLOW

GENERAL CORROSION

Nearside Front SHOCK BUSH WORN

OIL LEAK

Brake drum contaminated Nearside rear (1.1.14 (b))

Horn not working (7.7 (a))

Registration plate inscription missing Front (0.1 (b))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Suspension component mounting prescribed area fractured significantly reducing structural strength Nearside rear floor pan (5.3.6 (a) (i))

Windscreen washer not working (3.5 (a))

Nearside front shock bush worn

Oil leak

Slight exhaust blow

genaral corrosion

horn weak

Dipswitch does not operate immediately when selected on main beam Switch inoperative (4.1.3 (b))

Headlamp not working on main beam (4.1.1 (a) (ii))

Indicator switch inoperative (4.4.2 (a) (ii))

Nearside Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting Sill (6.2.2 (d) (i))

Nearside Rear Hydraulic brake cylinder leaking hydraulic fluid (1.1.16 (b) (i))

Offside Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting Sill (6.2.2 (d) (i))

Offside Rear Service brake excessively binding (1.2.1 (f))

Offside Rear Upper Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Speedometer clearly inoperative (7.8 (b) (ii))

Windscreen washer not working (3.5 (a))

Offside Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Rear Oil leak, but not excessive (8.4.1 (a) (i))

Steering box has slight free play detected at steering wheel (2.3 (a) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Fluid leak around near side rear back plate, brake efficiency ok.

General corrosion.

General corrosion

Electrical wiring insulation so damaged or deteriorated it is likely to cause a short-circuit Ingition (4.11 (c) (ii))

Hydraulic brake cylinder leaking hydraulic fluid Nearside rear wheel (1.1.16 (b) (i))

Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Nearside rear (5.3.6 (a) (i))

Fluid leak from nearside rear wheel area

Offside front wheel bearing slightly noisy

Leak n/s/r

Horn not working (1.6.2a)

Nearside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Leak n/s/r

Front registration plate deteriorated but not likely to be misread (6.3.1d)

Exhaust has a major leak of exhaust gases (7.1.2)

Horn not working (1.6.2a)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Front registration plate deteriorated but not likely to be misread (6.3.1d)

Rear Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Horn not working (1.6.2a)