2004 Toyota MR2

Parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (1.4.2 (a) (i))

Offside Stop lamp(s) not working (4.3.1 (a) (ii))

Parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (1.4.2 (a) (i))

Nearside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Parking brake inoperative on one side (1.4.1 (a))

Offside Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Stop lamp(s) with a multiple light source more than 1/2 not functioning centre brake light (4.3.1 (a) (ii))

Bonnet primary retaining device slightly deteriorated (3.1 (c))

Engine compartment catch stiff in operation.

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Brake pipe corroded, covered in grease or other material Both (1.1.11 (c))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Front Shock absorbers has a serious fluid leak (5.3.2 (b))

Offside Rear Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Bonnet primary retaining device slightly deteriorated (3.1 (c))

Engine compartment catch stiff in operation.

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Brake pipe corroded, covered in grease or other material Both (1.1.11 (c))

Front Registration plate insecure but not likely to fall off (0.1 (a))

Offside Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Rear Suspension component mounting repair covered in underseal subframe (5.3.6 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Brake pipe corroded, covered in grease or other material both (1.1.11 (c))

parking brake efficiency weak / on minimum

Front no.plate loose

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive inner wheel arch (2.4.A.3)

Rear Brake pipe slightly corroded (3.6.B.2c)

exhaust mounting strap broken

Rear Sub-frame corroded and seriously weakened (2.4.G.1)

Registration plate lamp not working both (1.1.C.1d)

Front no.plate loose

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive inner wheel arch (2.4.A.3)

Rear Brake pipe slightly corroded (3.6.B.2c)

exhaust mounting strap broken

Nearside Rear Parking brake lever has little reserve travel (3.1.6b)

Offside Front Brake hose ferrule excessively corroded all 4 brake hoses in poor condition (3.6.B.4e)

Parking brake: efficiency below requirements (3.7.B.7)

Nearside Rear Parking brake lever has little reserve travel (3.1.6b)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Parking brake lever has little reserve travel (3.1.6b)

lower exhaust heat shields insecure

Offside Front Brake hose has slight corrosion to ferrules (3.6.B.4e)

offside rear tyre , tread wearing low

Front Front position lamp(s) not working (1.1.A.3b)

Offside Side repeater not working (1.4.A.2c)

Parking brake: efficiency below requirements (3.7.C.1b)

Offside Front Brake hose has slight corrosion to ferrules (3.6.B.4e)

offside rear tyre , tread wearing low

Nearside Front position lamp(s) not working (1.1.A.3b)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Side repeater not working (1.4.A.2c)

Offside rear parking brake recording little or no effort (3.7.B.6a) DANGEROUS

Parking brake: efficiency below requirements (3.7.B.7) DANGEROUS

Nail in nearside rear tyre

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

Nail in nearside rear tyre

Offside Headlamp aim too high (1.8)

Offside Front position lamp(s) not working (1.1.A.3b)

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

engine management light on ;

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Windscreen washer provides insufficient washer liquid (8.2.3)