2008 Toyota Aygo

Front Sub-frame is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Front Sub-frame is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Nearside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Central Brake pipe corroded, covered in grease or other material both (1.1.11 (c))

Front Windscreen wiper blade defective (3.4 (b) (i))

Nearside Front Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Rear underbody corrosion

Nearside Rear Service brake excessively binding (1.2.1 (f))

Nearside Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Rear Service brake excessively binding (1.2.1 (f))

Nearside Rear Suspension component mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected outer sill @ rear (5.3.6 (a) (ii)) DANGEROUS

Offside Rear Suspension component mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected outer sill@ rear (5.3.6 (a) (ii)) DANGEROUS

Nearside Rear slight bind on brake

Offside Front shocker misting

Nearside Front Headlamp aim too high (4.1.2 (a))

Nearside Rear Brake pipe excessively corroded (1.1.11 (c))

Nearside Rear slight bind on brake

Offside Front shocker misting

Position lamp not working (4.2.1 (a) (ii))

Nearside Rear Service brake excessively binding (1.2.1 (f))

Offside Rear Service brake excessively binding (1.2.1 (f))

Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Nearside Rear Body modification likely to adversely affect braking or steering sill (6.2.1 (d) (ii)) DANGEROUS

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Front Brake pad(s) wearing thin (3.5.1g)

Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Registration plate lamp not working (1.1.C.1d)

Front wiper blade loose.

Brakes imbalanced across an axle (3.7.B.5b)

Nearside Headlamp aim too high (1.8)

Offside Headlamp aim too high (1.8)

Vehicle's internal headlight adjuster altered to recheck lights

Nearside Front Headlamp aim too low (1.8)