2002 Mazda Premacy

Nearside Front Lower Suspension arm ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Front Lower Suspension arm ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Rear Sub-frame corroded but not seriously weakened (2.4.G.1)

Rear registration plate deteriorated but not likely to be misread (6.3.1d)

Underside of vehicle coroded

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

brake disc worn, pitted or scored, but not seriously weakened All (3.5.1i)

rear section of floor slightly coroded

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Rear Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Rear Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Rear Suspension spring mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Rear registration plate deteriorated but not likely to be misread (6.3.1d)

Service brake: service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

the underside of the vehicle is covered in fresh underseal

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Nearside Rear Lower Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Nearside Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Lower Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside front brake binding (3.7.B.1)

rear suspension components heavily corroded

front brakes only just met the front brake imbalance requirements . it would appear that the braking system requires adjustment or repair rbt front brake imbalance 25%

Offside Registration plate lamp not working (1.1.C.1d)

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

exactly half ofthe high level lamp is fuctional

Offside Headlamp aim too low (1.8)

Rear Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

exactly half ofthe high level lamp is fuctional

Nearside Front Headlamp not working on dipped beam (1.7.5a)

Nearside Front Anti-roll bar linkage has slight play in a pin/bush (2.4.G.2)

Offside Rear Anti-roll bar linkage has slight play in a pin/bush (2.4.G.2)

o/s front tyre wearing on inner shoulder

Nearside Rear rear parking brake recording little or no effort (3.7.B.6a)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

extra return spring fitted on n\s rear caliper

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Rear Braking system leaking (3.6.A.1)

Parking brake: efficiency below requirements (3.7.B.7)

Registration plate lamp not working (1.1.5c)

Rear Brake pad(s) wearing thin (3.5.1g)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)