2006 Ford Ka

Exhaust has a minor leak of exhaust gases exhaust has slight blow at flexi section (6.1.2 (a))

Front Suspension component mounting prescribed area is corroded but not considered excessive both front floors corroded within 30cm of suspension mount (5.3.6 (a) (i))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement rearmost bush unbonding (5.3.4 (a) (i))

Offside Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive chassis corroding within 30cm of rear suspension mount (5.3.6 (a) (i))

Front Tyre(s) of different sizes are fitted on the same axle. different sized front tyres (5.2.3 (b))

Offside Front Outer Seat belt anchorage prescribed area strength or continuity significantly reduced outer sill holed within 30 cm of seat belt mount. (7.1.1 (a) (i))

Offside Headlamp aim not tested dip beam not working (4.1.2 (b))

Exhaust has a minor leak of exhaust gases exhaust has slight blow at flexi section (6.1.2 (a))

Front Suspension component mounting prescribed area is corroded but not considered excessive both front floors corroded within 30cm of suspension mount (5.3.6 (a) (i))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement rearmost bush unbonding (5.3.4 (a) (i))

Offside Front Inner Tyre worn close to legal limit/worn on edge tyre wearing on inner edge (5.2.3 (e))

Offside Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive chassis corroding within 30cm of rear suspension mount (5.3.6 (a) (i))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement LOWER ARM REAR BUSH STARTING TO UNBOND. (5.3.4 (a) (i))

Nearside Front Seat belt anchorage prescribed area strength or continuity significantly reduced OUTER SILL HOLED WITHIN 30CM OF SEAT BELT MOUNT. (7.1.1 (a) (i))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength OUTER SILL HOLED WITHIN 30CM OF FRONT SUSPENSION MOUNT. (5.3.6 (a) (i))

Offside Front Direction indicator not working (4.4.1 (a) (ii))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement LOWER ARM REAR BUSH STARTING TO UNBOND. (5.3.4 (a) (i))

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement REARMOST BUSH UNBONDING SLIGHTLY. (5.3.4 (a) (i))

Suspension component mounting prescribed area is corroded but not considered excessive BOTH FRONT FLOORS BEGINNING TO CORRODE WITHIN 30CM OF FRONT SUSPENSION MOUNTINGS. (5.3.6 (a) (i))

Nearside Headlamp aim too high (4.1.2 (a))

Nearside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength INNER WHEELARCH / SILL END HOLED WITHIN 30CM OF SUSPENSION MOUNTING. (5.3.6 (a) (i))

Offside Headlamp aim too low (4.1.2 (a))

Offside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength OUTER SILL / INNER WHEELARCH (SILL END) HOLED WITHIN 30CM OF SUSPENSION MOUNTING. (5.3.6 (a) (i))

Rear fog lamp not working (4.5.1 (a) (ii))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement REARMOST BUSH BEGINNING TO UNBOND. (5.3.4 (a) (i))

Suspension component mounting prescribed area is corroded but not considered excessive BOTH FRONT FLOORS BEHIND FRONT SUSPENSION MOUNTINGS. (5.3.6 (a) (i))

Nearside Headlamp aim too high (4.1.2 (a))

Nearside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength INNER WHEELARCH / SILL END HOLED WITHIN 30CM OF SUSPENSION MOUNTING. (5.3.6 (a) (i))

Offside Headlamp aim too low (4.1.2 (a))

Offside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength OUTER SILL / INNER WHEELARCH (SILL END) HOLED WITHIN 30CM OF SUSPENSION MOUNTING. (5.3.6 (a) (i))

Rear fog lamp not working (4.5.1 (a) (ii))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement REARMOST BUSH BEGINNING TO UNBOND. (5.3.4 (a) (i))

Suspension component mounting prescribed area is corroded but not considered excessive BOTH FRONT FLOORS BEHIND FRONT SUSPENSION MOUNTINGS. (5.3.6 (a) (i))

Offside Body has a sharp edge caused by corrosion body sill badly corroded (6.1.C.1)

Offside Front Tyre worn close to the legal limit wearing thin on inner edge (4.1.E.1)

Offside Seat belt anchorage prescribed area is corroded but not considered excessive outer body sill starting to corrode (5.2.6)

Nearside Headlamp not working on dipped beam (1.7.5a)