2002 Jaguar X-type

Corrosion Under Vehicle

Front Brake pad(s) wearing thin ns/os (3.5.1g)

Front Brake pipe slightly corroded ns/os (3.6.B.2c)

Front Tyre worn close to the legal limit ns/os (4.1.E.1)

Front brake disc worn, pitted or scored, but not seriously weakened ns/os (3.5.1i)

Lower Brake pipe slightly corroded (3.6.B.2c)

Nearside Front Anti-roll bar ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Nearside Front Lower Suspension arm ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Nearside Front wheel bearing has slight play (2.5.A.3c)

Rear brake disc worn, pitted or scored, but not seriously weakened ns/os (3.5.1i)

Rear coil spring corroded ns/os (2.4.C.1b)

rear parking (secondary) brake imbalance requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.6b)

Anti-lock braking system warning lamp indicates an ABS fault (3.4.1c)

Nearside Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Headlamp aim too high (1.8)

Offside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Anti-lock braking system warning lamp indicates an ABS fault (3.4.1c)

Brake pipe excessively corroded (3.6.B.2c)

Headlamp aim too low (1.8)

Nearside Front Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Nearside Front Macpherson strut has excessive movement in the upper support bearing assembly (2.5.B.1b)

Nearside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Rear Anti-roll bar has excessive play in a pin/bush (2.4.G.2)

Nearside Rear Shock absorber has an excessively worn bush (2.7.4)

Offside Front Macpherson strut has excessive movement in the upper support bearing assembly (2.5.B.1b)

Offside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Headlamp not working on main beam (1.7.5a)

Offside Rear Anti-roll bar has excessive play in a pin/bush (2.4.G.2)

Offside Rear Shock absorber has an excessively worn bush (2.7.4)

Parking brake: efficiency below requirements (3.7.B.7)

Windscreen washer provides insufficient washer liquid (8.2.3)

engin management light on-x2 rear coil springs corroded-wishbone bushes slightly perished-x2 inner and outter sills corroded-engine and gearbox mounts defective

Brake pipe slightly corroded (3.6.B.2c)

Nearside Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)