2004 Subaru Forester

Front Windscreen wiper does not clear the windscreen effectively both (3.4 (b) (ii))

Nearside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced inner arch (7.1.1 (a) (i))

Offside Rear Inner Seat belt anchorage prescribed area strength or continuity significantly reduced arch (7.1.1 (a) (i))

Headlamp lens slightly defective both (4.1.1 (b) (i))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Rear Exhaust mounting defective x2 (6.1.2 (a))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material rear part of front to rear (1.1.11 (c))

Offside Rear Brake pipe corroded, covered in grease or other material Rear part of front to rear (1.1.11 (c))

Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement BOTH (5.3.4 (a) (i))

Nearside Rear Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Rear Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Nearside Front Anti-roll bar linkage cracked (2.4.G.1)

Offside Rear Registration plate lamp not working (1.1.C.1d)

Supplementary Restraint System warning lamp indicates a fault (5.4.2)

Front Brake pad(s) wearing thin (3.5.1g)

Front Exhaust has a minor leak of exhaust gases (7.1.2)

Rear Brake pad(s) wearing thin (3.5.1g)

Battery insecure (1.9.1)

Front Brake pad(s) wearing thin (3.5.1g)

Front Exhaust has a minor leak of exhaust gases (7.1.2)

Rear Brake pad(s) wearing thin (3.5.1g)

exhaust blowing at front

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Both front brake discs pitted

Front Brake pad(s) wearing thin (3.5.1g)

Windscreen has a sticker or other obstruction encroaching by more than 10mm within zone 'A' (8.3.1b)

Windscreen has a sticker or other obstruction encroaching into the swept area by more than 40mm outside zone 'A' (8.3.1e)