2005 Mazda 6

Front Brake pipe corroded, covered in grease or other material both sides at flexi slightly corroded (1.1.11 (c))

Nearside Front Service brake excessively binding (1.2.1 (f))

Nearside Rear Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting back of sill (6.2.2 (d) (i))

Offside Rear Service brake excessively binding (1.2.1 (f))

Rear Brakes imbalanced across an axle 44% (1.2.1 (b) (i))

Front Brake pipe corroded, covered in grease or other material both sides at flexi slightly corroded (1.1.11 (c))

Offside Front Upper Suspension arm ball joint has slight play (5.3.4 (a) (i))

Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Rear Outer Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced sill section (6.1.1 (c) (i))

Nearside Rear Anti-roll bar linkage fractured (2.4.G.1)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

parking brake performance only just met requirement

Supplementary Restraint System warning lamp indicates a fault (5.4.2)

Nearside Headlamp not working on dipped beam (1.7.5a)

Nearside Front Lower Suspension arm ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

slight play in o/s/f wheel bearing

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Headlamp aim too low (1.8)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

n/s/r tyre getting low