2006 Toyota Aygo

Headlamp aim projected beam image is obviously incorrect lenes clouded (4.1.2 (c))

Nearside Rear Service brake excessively binding (1.2.1 (f))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Front Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Offside Rear Position lamp not working (4.2.1 (a) (ii))

Offside Stop lamp(s) not working (4.3.1 (a) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Service brake efficiency below requirements (1.2.2 (a) (i))

Windscreen washer not working (3.5 (a))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Outer sills showing signs of corrosion

Rear Beam bushes corroded

surface surface corrosion to underside

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Front Exhaust system insecure mount corroded off (6.1.2 (a))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Outer sills showing signs of corrosion

Rear Beam bushes corroded

surface surface corrosion to underside

Brake pipe corroded, covered in grease or other material front too rear at rear (1.1.11 (c))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Rear Coil spring corroded (5.3.1 (b) (i))

Rear beam bushes coroded

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Parking brake inoperative on one side (1.4.1 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Brake pipe corroded, covered in grease or other material front too rear at rear (1.1.11 (c))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Rear Coil spring corroded (5.3.1 (b) (i))

Rear beam bushes coroded

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

surface corrosion too underside

wipers poor

Nearside Rear Service brake excessively binding (1.2.1 (f))

Offside Indicator switch inoperative (4.4.2 (a) (ii))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

surface corrosion too underside

wipers poor

Front Registration plate deteriorated but not likely to be misread damaged (0.1 (b))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust emissions likely to be affected by an exhaust leak (8.2.1.1 (b))

Nearside Headlamp aim too high (4.1.2 (a))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Headlamp aim too low (4.1.2 (a))

Offside Rear Service brake excessively binding (1.2.1 (f))

Exhaust noisy rear box (8.1.1 (a))

Front Registration plate deteriorated but not likely to be misread damaged (0.1 (b))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear parking brake low effort

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust emissions likely to be affected by an exhaust leak (8.2.1.1 (b))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Nearside Stop lamp(s) not working (4.3.1 (a) (ii))

Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Headlamp aim too low (1.8)

Offside Headlamp aim too low (1.8)

Offside Registration plate lamp not working (1.1.C.1d)

Windscreen washer provides insufficient washer liquid (8.2.3)

Brake fluid warning lamp illuminated (3.6.G.2)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Headlamp aim too high (1.8)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Headlamp aim too high (1.8)

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)