2008 Ford Ka

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced Both outer & inner sills (6.1.1 (c) (i))

Offside Rear Position lamp not working (4.2.1 (a) (ii))

Offside Rear Service brake excessively binding (1.2.1 (f))

Offside Rear Wheel bearing rough when rotated (5.1.3 (b) (i))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Front Brake pipe excessively corroded (1.1.11 (c))

Nearside Front Service brake excessively binding (1.2.1 (f))

Nearside Headlamp aim too low (4.1.2 (a))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Sub-frame pin or bush excessively worn Both rear (5.3.4 (a) (i))

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Exhaust system not adequately supported centre section (7.1.1)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Brake hydraulic reservoir fluid level below minimum level (3.6.G.1b)

Brakes imbalanced across an axle (3.7.B.5b)

Nearside Rear Rear position lamp(s) not working (1.1.A.3b)

Offside Front Headlamp aim beam image obviously incorrect (1.8.A.1b)

Offside Rear Stop lamp not working (1.2.1b)

advise frontbrake discs worn and pitted

advise handbrake warning light staying on

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

front brake inbalance 22

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)