2013 Seat Leon

Nearside Front Brake disc worn, but not excessively (1.1.14 (a) (i))

Nearside Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Rear Service brake excessively binding (1.2.1 (f))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Offside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Rear Brake disc significantly and obviously worn (1.1.14 (a) (i))

Offside Rear Service brake excessively binding (1.2.1 (f))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Offside Rear Inner Brake pad(s) less than 1.5 mm thick pad (1.1.13 (a) (ii)) DANGEROUS

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Nearside Rear tyre perishing sidewalls

Rear axle slight corrosion around mountings

both front tyres worn inner edge and perishing

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Brake hydraulic reservoir fluid close to minimum level (3.6.G.1b)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Rear tyre worn outer edge and splitting in treads

Offside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Rear Tyre worn close to the legal limit 1.6mm plus nail in tread (4.1.E.1)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)