2006 Seat Leon

Nearside Front Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Offside Front Body panel corroded and likely to cause injury wing (6.2.1 (a) (i))

Nearside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Nearside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security wing (6.2.2 (d) (i))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Rear Coil spring fractured or broken (5.3.1 (b) (i))

Nearside Rear Shock absorbers has a serious fluid leak (5.3.2 (b))

Offside Rear Coil spring corroded so that its cross sectional area is reduced and seriously weakened (5.3.1 (b) (i))

Offside Rear Shock absorbers has a serious fluid leak (5.3.2 (b))

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Nearside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security wing (6.2.2 (d) (i))

Both front tyres inner edges close to limit of wear

rear exhaust is corroded and deteriorated

front tyres worn on inside edge

rear exhaust deteriorated

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Rear Brake pad(s) wearing thin (3.5.1g)

Offside Front Seat belt damaged but not affecting the operation of the belt (5.2.2a)