2012 Mercedes-benz C

Both offside brake lines badly corroded underneath

Nearside front tyre bald on outer edge

Rear Coil spring corroded Both (5.3.1 (b) (i))

Bonnet primary retaining device ineffective Both (3.1 (c))

Front Lower Suspension arm ball joint excessively worn Cross struts, both (5.3.4 (a) (i))

Bad engine oil leak.

Both offside brake lines badly corroded underneath

Nearside front tyre bald on outer edge

Rear Coil spring corroded Both (5.3.1 (b) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Front Brake disc worn, but not excessively (1.1.14 (a) (i))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Front Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Front Tyre has a bulge, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Front Brake disc worn, but not excessively (1.1.14 (a) (i))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Engine MIL inoperative or indicates a malfunction (8.2.2.2 (g))

Nearside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii))

Offside Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii))

Offside Front Tyre has a cut but not deep enough to reach the ply or cords inner and outer edges starting to crack (5.2.3 (d) (i))

Offside Rear Tyre has a cut but not deep enough to reach the ply or cords inner and outer edges starting to crack (5.2.3 (d) (i))

covers fitted obscuring some components

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

covers fitted unable to fit all components.