2007 Seat Altea

Front Headlamp aim too low both (4.1.2 (a))

Front Headlamp levelling device inoperative (4.1.5 (a))

Nearside Front Service brake excessively binding (1.2.1 (f))

Nearside Front Shock absorbers has a serious fluid leak (5.3.2 (b))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Exhaust emits excessive smoke or vapour likely to obscure the vision of other road users (8.2.2.2 (c)) DANGEROUS

Nearside Front Inner Tyre slightly damaged/cracking or perishing sidewall (5.2.3 (d) (ii))

Nearside Front Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

surface corrosion to suspension components

Nearside Front Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Nearside Rear Position lamp not working (4.2.1 (a) (ii))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

surface corrosion to suspension components

surface corrosion to suspension components

Offside Rear Position lamp not working (4.2.1 (a) (ii))

surface corrosion to suspension components

Exhaust emits blue smoke during acceleration (8.2.1.2 (g))

Nearside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Offside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

central locking fault offside rear door

engine to manifold egr pipe leaking gases at manifold end

esp light illuminated

front brake disks lipped

general under body corrosion

handbrake cable guide tube broken, nearside rear

offside front and both rear coil springs corroding

offside rear tyre inner edge wearing

tpms light indicates flat tyre, visual inspection proven not to be the case

Offside Outer Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

Nearside Front position lamp(s) not working (1.1.A.3b)

Offside Front Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Offside Rear Registration plate lamp not working (1.1.C.1d)

Tyre pressure monitoring system warning lamp indicates a fault (4.1.D.4)

Offside Outer Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

Offside Rear Nail in tyre ()

Nearside Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

deterioration on rear exhaust silencer box.

Nearside Rear Outer Rear position lamp(s) not working (1.1.A.3b)

Nearside Stop lamp not working (1.2.1b)

Offside Rear Tyre has a tear, caused by separation or partial failure of its structure (4.1.D.1b)

Tyre pressure monitoring system warning lamp indicates a fault (4.1.D.4)

Nearside Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

deterioration on rear exhaust silencer box.

Tyre pressure monitoring system warning lamp does not illuminate (4.1.D.4)

exhaust corroded

Front brake disc in such a condition that it is seriously weakened (3.5.1i)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.C.1b)

Tyre pressure monitoring system warning lamp does not illuminate (4.1.D.4)

exhaust corroded

Offside Rear Brake pad(s) wearing thin (3.5.1g)

Front Brake pad(s) wearing thin (3.5.1g)

Offside Headlamp deteriorated but light output not reduced (1.7.5a)

Offside Rear Brake pad(s) wearing thin (3.5.1g)

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)