2003 Subaru Forester

Central Suspension arm pin or bush excessively worn support beam n/s (5.3.4 (a) (i))

Central Suspension arm pin or bush excessively worn support beam o/s (5.3.4 (a) (i))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Nearside Front Anti-roll bar ball joint excessively worn (5.3.4 (a) (i))

Nearside Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Nearside Rear Anti-roll bar ball joint excessively worn (5.3.4 (a) (i))

Nearside Rear Subframe mounting prescribed area excessively corroded significantly reducing structural strength several places (5.3.6 (a) (i))

Offside Front Anti-roll bar ball joint excessively worn (5.3.4 (a) (i))

Offside Rear Anti-roll bar ball joint excessively worn (5.3.4 (a) (i))

Offside Rear Subframe mounting prescribed area excessively corroded significantly reducing structural strength several places (5.3.6 (a) (i))

Nearside Rear Shock absorbers has a reduced damping effect (5.3.2 (d))

Offside Rear Shock absorbers has a reduced damping effect (5.3.2 (d))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Rear Shock absorbers has a reduced damping effect (5.3.2 (d))

Nearside Rear Shock absorbers has light misting of oil (5.3.2 (b))

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive cross member (5.3.6 (a) (i))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Central Rear Rear fog lamp not working (4.5.1 (a) (ii))

Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Offside Front position lamp(s) not working (1.1.A.3b)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

n/s/f anti roll bar link has slight play

front brake pads may be getting low

n/s/r tyre wearing on inside

Offside Rear Tyre has ply or cords exposed (4.1.D.1b)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)