2003 Mercedes-benz Vito

Exhaust has a major leak of exhaust gases (6.1.2 (a))

Nearside Front Inner Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Nearside Front Seat belt anchorage prescribed area strength or continuity significantly reduced inner and outer sills (7.1.1 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner and outer sill (5.3.6 (a) (i))

Nearside Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Nearside Side repeater incorrect colour (4.4.3 (a))

Offside Front Seat belt anchorage prescribed area strength or continuity significantly reduced inner and outer sills (7.1.1 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner and outer sill (5.3.6 (a) (i))

Offside Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Brake disc worn, but not excessively both front (1.1.14 (a) (i))

Nearside Side repeater lens defective which has no effect on emitted light (4.4.1 (b) (i))

Offside Front Inner Drive shaft joint worn, but not excessively (6.1.7 (c) (i))

Offside Front Lower Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

BOTH FRONT WHEEL ARCHES AND FRONT AND REAR DOORS CORRODED

Brake disc worn, pitted or scored, but not seriously weakened both front and rear (1.1.14 (a) (ii))

Brake pipe corroded, covered in grease or other material fronts and osr (1.1.11 (c))

Coolant leak ()

Front Anti-roll bar pin or bush worn but not resulting in excessive movement both sides (5.3.4 (a) (i))

Front Brake pad(s) wearing thin both sides (1.1.13 (a) (ii))

Front Headlamp has a product on the lens but not seriously reducing light output both sides (4.1.4 (b))

Front Inner Steering linkage ball joint has slight play BOTH SIDES (2.1.3 (b) (i))

Front Side repeater slightly discoloured both sides near side lens missing (4.4.3 (a))

Nearside Front Inner Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Nearside Front Inner Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security sill (6.2.2 (d) (i))

Nearside Rear Lower fuel filler neck cover corroded and in very poor condition

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

BOTH FRONT WHEEL ARCHES AND FRONT AND REAR DOORS CORRODED

Brake disc worn, pitted or scored, but not seriously weakened both front and rear (1.1.14 (a) (ii))

Brake pipe corroded, covered in grease or other material fronts and osr (1.1.11 (c))

Coolant leak ()

Front Anti-roll bar pin or bush worn but not resulting in excessive movement both sides (5.3.4 (a) (i))

Front Brake pad(s) wearing thin both sides (1.1.13 (a) (ii))

Front Headlamp has a product on the lens but not seriously reducing light output both sides (4.1.4 (b))

Front Inner Steering linkage ball joint has slight play BOTH SIDES (2.1.3 (b) (i))

Front Position lamp not working both sides (4.2.1 (a))

Front Side repeater slightly discoloured both sides near side lens missing (4.4.3 (a))

Nearside Front Inner Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Nearside Front Inner Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security sill (6.2.2 (d) (i))

Nearside Rear Lower fuel filler neck cover corroded and in very poor condition

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

front to rear brake pipes rusty

o/s outer sill rusty

o/s/f headlamp condensated

o/s/f inner c/v boot deteriorated

rear brake pipes rusty

rear no plate deteriorated

Nearside Front Inner Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Nearside Rear Brake pipe excessively corroded (3.6.B.2c)

Offside Registration plate lamp not working (1.1.C.1d)

front to rear brake pipes rusty

o/s outer sill rusty

o/s/f headlamp condensated

o/s/f inner c/v boot deteriorated

rear brake pipes rusty

rear no plate deteriorated

Nearside Front Headlamp not working on dipped beam (1.7.5a)

n/s mirror cracked

rear brakes noisey

windscreen marked

Brake fluid warning lamp illuminated (3.6.G.2)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Obligatory mirror seriously damaged, affecting the rear view (8.1.2a)

Nearside Registration plate lamp not fitted (1.1.C.1b)

Offside Front Lower Anti-roll bar linkage ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Registration plate lamp not working (1.1.C.1d)

Parking brake: efficiency below requirements (3.7.B.7)

Windscreen washer provides insufficient washer liquid (8.2.3)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

n/s/r tyre perished

n/s/r tyre worn to limits

rear brake discs very rusty

windscreen damaged

Nearside Front Brake pipe excessively corroded (3.6.B.2c)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Inner Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Parking brake: efficiency below requirements (3.7.B.7)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

nearside rear tyre tread perishing

rear brake discs excessively rusty and pitted

Nearside Front Upper Anti-roll bar linkage ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Nearside Obligatory mirror damaged, but not seriously affecting the rear view (8.1.2a)

Nearside Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

slight condensation in both headlamp lenses

condensation in headlamps

n/s rear tyre worn on edges

n/s/mirror glass cracked

o/s/r tyre worn to limit

windscreen damaged

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

Parking brake lever has little reserve travel (3.1.6b)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

condensation in both headlamps

nearside mirror glass cracked but view to rear not affected

nearside rear tyre wearing on edges

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Rear Stop lamp not working (1.2.1b)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Headlamp damaged but light output not reduced (1.7.5a)

Brakes imbalanced across an axle (3.7.B.5b)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Headlamp damaged but light output not reduced (1.7.5a)

Horn not working (1.6.2a)

Rear registration plate deteriorated (6.3.1d)

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a) DANGEROUS

Offside Stop lamp not working (1.2.1b)