2008 Chrysler-jeep 300

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Wheel bearing has slight play (5.1.3 (a) (i))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Upper Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Direction indicator slightly discoloured (4.4.3 (a))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front Tyre worn close to legal limit/worn on edge outer edge (5.2.3 (e))

Nearside Front Tyre worn close to legal limit/worn on edge outer edge (5.2.3 (e))

Nearside Rear Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Offside Front Position lamp not working (4.2.1 (a))

Offside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

front tyres starting to wear on inner edges

Anti-lock braking system warning lamp indicates an ABS fault (3.4.1c)

Electronic stability system warning lamp indicates a fault (3.4.1c)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Front Tie bar/rod rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Nearside Headlamp aim too high (1.8)

Offside Front Upper Suspension arm has excessive play in a ball joint (2.4.G.2)

Offside Headlamp aim too high (1.8)

Parking brake: efficiency below requirements (3.7.B.7)

Nearside Rear wheel bearing has slight play (2.6.2)

Offside Rear wheel bearing has slight play (2.6.2)

Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Tyre pressure monitoring system warning lamp does not illuminate (4.1.D.4)

front tyres starting to wear on inner edges

n/s/f tyre has small cut in outer side wall

Nearside Front Front position lamp(s) not working (1.1.A.3b)

Nearside Rear Registration plate lamp not working (1.1.C.1d)

Offside Front Front position lamp(s) not working (1.1.A.3b)

Parking brake lever pawl spring does not push the pawl positively into the ratchet teeth (3.1.5)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

n/s/f tyre has small cut in outer side wall

no emission printout due to low emission output

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake lever has no reserve travel (3.1.6b)

Parking brake: efficiency below requirements (3.7.B.7)