2011 Citroen DS3

Front Lower Suspension arm pin or bush worn but not resulting in excessive movement both sides (5.3.4 (a) (i))

Front Tyre worn close to legal limit/worn on edge both sides (5.2.3 (e))

Front Upper Macpherson strut pin or bush worn but not resulting in excessive movement both sides (5.3.4 (a) (i))

Nearside Front Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Rear Brake disc worn, pitted or scored, but not seriously weakened both sides (1.1.14 (a) (ii))

Rear Brake hose has slight corrosion to ferrule both sides (1.1.12 (f) (i))

Front Lower Suspension arm pin or bush worn but not resulting in excessive movement both sides (5.3.4 (a) (i))

Front Tyre worn close to legal limit/worn on edge both sides (5.2.3 (e))

Front Upper Macpherson strut pin or bush worn but not resulting in excessive movement both sides (5.3.4 (a) (i))

Front Windscreen washer provides insufficient washer liquid (3.5 (a))

Nearside Front Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Rear Brake disc worn, pitted or scored, but not seriously weakened both sides (1.1.14 (a) (ii))

Rear Brake hose has slight corrosion to ferrule both sides (1.1.12 (f) (i))

Brake hose has slight corrosion to ferrule both rear (1.1.12 (f) (i))

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Offside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Offside Front Macpherson strut mounting corroded but not seriously weakened (5.3.3 (b) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Suspension arm pin or bush worn but not resulting in excessive movement both front arms rear bushes cracking (5.3.4 (a) (i))

Suspension component mounting prescribed area is corroded but not considered excessive both rear axle mountings (5.3.6 (a) (i))

Suspension spring mounting prescribed area is corroded but not considered excessive both rear upper coil spring mountings corroded (5.3.6 (a) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced both rear chassis rails corroded (6.1.1 (c) (i))

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Electronic stability control warning lamp indicates a fault (7.12 (e))

Offside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Rear Coil spring fractured or broken (5.3.1 (b) (i))

Position lamp not working both front (4.2.1 (a) (ii))

Stop lamp(s) not working both rear (4.3.1 (a) (ii))

Brake hose has slight corrosion to ferrule both rear (1.1.12 (f) (i))

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Offside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Offside Front Macpherson strut mounting corroded but not seriously weakened (5.3.3 (b) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Suspension arm pin or bush worn but not resulting in excessive movement both front arms rear bushes cracking (5.3.4 (a) (i))

Suspension component mounting prescribed area is corroded but not considered excessive both rear axle mountings (5.3.6 (a) (i))

Suspension spring mounting prescribed area is corroded but not considered excessive both rear upper coil spring mountings corroded (5.3.6 (a) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced both rear chassis rails corroded (6.1.1 (c) (i))

Windscreen wiper blade defective both front smearing (3.4 (b) (i))

Nearside Rear Outer Nail in tyre

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Offside Front Inner Tyre has a cut but not deep enough to reach the ply or cords (5.2.3 (d) (i))

Offside Front Service brake binding but not excessively (1.2.1 (f))

Nearside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Rear Outer Nail in tyre

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Offside Front Inner Tyre has a cut but not deep enough to reach the ply or cords (5.2.3 (d) (i))

Offside Front Service brake binding but not excessively (1.2.1 (f))

Offside Outer Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting sill (6.2.2 (d) (i))

Windscreen washer not working (3.5 (a))

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Nearside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Coil spring fractured or broken (5.3.1 (b) (i))

Brake disc in such a condition that it is seriously weakened front and rear (1.1.14 (a) (ii)) DANGEROUS

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Front Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Engine covers & undertrays fitted.

Front registration plate deteriorated but not likely to be misread (6.3.1d)

Nearside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Nearside Rear Tyre worn close to the legal limit 205/45/17. (4.1.E.1)

Nearside Registration plate lamp not working (1.1.C.1d)

Nearside Stop lamp not working (1.2.1b)

Offside Front Tyre has ply or cords exposed 205/45/17. (4.1.D.1b)

Offside Registration plate lamp not working (1.1.C.1d)

Offside rear brake binding (3.7.B.1)

Engine covers & undertrays fitted.

Front registration plate deteriorated but not likely to be misread (6.3.1d)

Nearside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Nearside Rear Tyre worn close to the legal limit 205/45/17. (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Track rod end ball joint has excessive play (2.2.B.1f)

Offside Front Front constant velocity joint gaiter insecure to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Exhaust system not adequately supported (7.1.1)

Nearside Front Suspension arm has excessive play in a ball joint (2.4.G.2)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Front Track rod end ball joint has slight play (2.2.B.1f)

Nearside Rear Brake pad(s) wearing thin (3.5.1g)

Offside Rear Brake pad(s) wearing thin (3.5.1g)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

exhaust hangers not supporting exhaust

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

exhaust hangers not supporting exhaust

front and rear brake pads wearing thin

Anti-lock braking system warning lamp indicates an ABS fault (3.4.1c)

Nearside Headlamp not working on dipped beam (1.7.5a)

front and rear brake pads wearing thin