2006 Seat Alhambra

Nearside Integral body structure is corroded but structural rigidity is not significantly reduced inner sill (6.1.1 (c) (i))

Offside Integral body structure is corroded but structural rigidity is not significantly reduced inner sill (6.1.1 (c) (i))

Nearside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength floor/sill area (5.3.6 (a) (i))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Rear Anti-roll bar linkage pin or bush excessively worn (5.3.4 (a) (i))

Rear Suspension arm corroded but not seriously weakened nearside and offside (5.3.3 (b) (i))

Suspension component mounting prescribed area is corroded but not considered excessive most areas underbody (5.3.6 (a) (i))

Nearside Front Lower Anti-roll bar ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Rear Lower Subframe mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Front Lower Anti-roll bar ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Front Lower Subframe mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Rear Lower Subframe mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Power steering component(s) has slight seepage from a component (2.3.3b)

n/s/f lower arm rear bush starting to seperate

stonechips to windscreen

front brake discs getting worn

rear exhaust pipe and box getting rusty

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)