2006 Subaru Legacy

Nearside Body component damaged and likely to cause injury mirror case (6.2.1 (a) (i))

Nearside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Nearside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength wheel arch (5.3.6 (a) (i))

Offside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Offside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength wheel arch (5.3.6 (a) (i))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))

Nearside Non obligatory mirror damaged ()

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Rear Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Sub-frame is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

outer sill covers fitted at time of test

Brake performance not tested (1.2.1 (g))

Offside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Rear Brake pipe leaking on a hydraulic braking system front to rear pipe under underbody tray at rear (1.1.11 (b) (ii)) DANGEROUS

Nearside Rear Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Offside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Nearside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Front Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt insecure (6.1.7 (g) (ii))

Offside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

engine covers fitted preventing full inspection of some components

Offside Rear Anti-roll bar has slight play in a ball joint (2.4.G.2)

Front Brake pad(s) wearing thin (3.5.1g)

Front Tyre worn close to the legal limit (4.1.E.1)

Rear Brake pad(s) wearing thin (3.5.1g)

Tyre worn close to the legal limit (4.1.E.1)

Tyre worn close to the legal limit (4.1.E.1)