2013 Mercedes-benz Vito

Emission value removed from chassis plate

Exhaust silencer slightly loose Clamp missing (8.1.1 (b) (i))

Handbrake balance poor (Nearside low)

Offside Rear Nail in tyre ()

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Engine MIL inoperative or indicates a malfunction (8.2.2.2 (g))

Front Windscreen washer provides insufficient washer liquid (3.5 (a))

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Offside Side repeater incorrect colour (4.4.3 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Emission value removed from chassis plate

Exhaust silencer slightly loose Clamp missing (8.1.1 (b) (i))

Offside Rear Nail in tyre ()

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Nearside Rear Tyre worn close to legal limit/worn on edge Tyre worn and perished/cracked (5.2.3 (e))

SRS warning lamp was on initially , but went out during test

Offside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Nearside Rear Tyre worn close to legal limit/worn on edge Tyre worn and perished/cracked (5.2.3 (e))

SRS warning lamp was on initially , but went out during test

under vehicle and brake pipes surface corrosion

Exhaust emissions exceed manufacturer's specified limit (8.2.2.2 (a))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Front Brake disc worn, but not excessively (1.1.14 (a) (i))

Rear Brake disc worn, but not excessively (1.1.14 (a) (i))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Front Track rod end ball joint has excessive play (2.2.B.1f)