2003 Toyota Yaris

Front Brakes imbalanced across an axle Axle 1 (1.2.1 (b) (i))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Front Service brake lagging in operation (1.2.1 (d))

Nearside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Front Inner Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Service brake excessively fluctuating (1.2.1 (e))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Service brake efficiency below requirements (1.2.2 (a) (i))

Windscreen washer provides insufficient washer liquid (3.5 (a))

Offside Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Inner Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))

Offside Inner Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))

Play in steering rack inner joint(s) ()

Suspension arm corroded but not seriously weakened all arms (5.3.3 (b) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Front Shock absorbers has negligible damping effect both front shockers (5.3.2 (d))

Nearside Front Anti-roll bar linkage pin or bush excessively worn (5.3.4 (a) (i))

Nearside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Rear Brake pipe excessively corroded (1.1.11 (c))

Rear Axle swivel pins and bushes swivel pin and/or bush slightly worn (5.1.2 (b) (i))

Front Position lamp not working (4.2.1 (a) (ii))

Offside Front Inner Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Rear Brake pipe excessively corroded (1.1.11 (c))

Rear Rear fog lamp not working (4.5.1 (a) (ii))

Rear Registration plate lamp does not illuminate simultaneously with the position lamps (4.7.2 (a))

Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Rear Axle swivel pins and bushes swivel pin and/or bush slightly worn (5.1.2 (b) (i))

Front Service brake fluctuating, but not excessively (1.2.1 (e))

Nail in tyre both rear and nearside front plus cut in nearside front wall ()

nearside front brake pads approaching replacement stage

offside front repeater lens missing

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Front Road wheel fixing missing snapped (5.2.1 (a) (i))

Nearside Parking brake inoperative on one side plus low offside reading (1.4.1 (a))

Offside Rear fog lamp not working (4.5.1 (a) (ii))

Windscreen washer not working both[ no motor working] (3.5 (a))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Front Service brake fluctuating, but not excessively (1.2.1 (e))

Nail in tyre both rear and nearside front plus cut in nearside front wall ()

nearside front brake pads approaching replacement stage

offside front repeater lens missing

Nearside Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Nearside Headlamp lens slightly defective (4.1.1 (b) (i))

Offside Headlamp lens slightly defective (4.1.1 (b) (i))

Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Rear Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside rear brake binding (3.7.B.1)

Rear Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Rear Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Stop lamp not working (1.2.1b)

Rear Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Rear Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

exhaust corroded

Nearside Headlamp excessively deteriorated so that the light output is severely reduced (1.7.5a)

Nearside Rear position lamp(s) not working (1.1.A.3b)

Nearside Stop lamp not working (1.2.1b)

Offside Headlamp excessively deteriorated so that the light output is severely reduced (1.7.5a)

Offside Rear Mechanical brake component has restricted free movement (3.5.1k)

Offside Rear fog lamp not working (1.3.2b)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Rear Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

exhaust corroded

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside rear brake binding (3.7.B.1)

Parking brake lever has no reserve travel (3.1.6b)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Parking brake lever has little reserve travel (3.1.6b)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Stop lamp not working (1.2.1b)

both rear tyres cracking

Registration plate lamp not working (1.1.5c)

Windscreen washer provides insufficient washer liquid (8.2.3)