2005 Audi Tt

Nearside Front Wheel bearing rough when rotated (5.1.3 (b) (i))

Nearside Rear Hydraulic brake calliper leaking (1.1.16 (b) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened Worn on inner face (1.1.14 (a) (ii))

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Nearside Front Upper Anti-roll bar ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Front Upper Anti-roll bar ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Lower Oil leaking continuously from engine posing a serious risk to road safety between engine and gear box underneath (8.4.1 (a) (ii)) DANGEROUS

Nearside Rear Hydraulic brake calliper leaking and braking performance affected (1.1.16 (b) (ii)) DANGEROUS

Nearside Front Tyre has a cut but not deep enough to reach the ply or cords (5.2.3 (d) (i))

Offside Rear Brake disc worn, but not excessively shows signs of heating red hot (1.1.14 (a) (i))

Offside Rear Brake pad(s) wearing thin worn almost to legal limit (1.1.13 (a) (ii))

reverse light not working

small split in o/s front anti-roll bar link

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Oil leak on engine ()

Driver's airbag obviously defective (5.4.1)

Offside Rear coil spring broken (2.4.C.1a)

Oil leak on engine ()

Front registration plate deteriorated but not likely to be misread (6.3.1d)

Rear Brake pad(s) wearing thin (3.5.1g)

Centre exhaust mount broken

Engine covers fitted obscuring some components in the engine bay

Offside front tyre bald on inside edge

Offside rear tyre low on inside edge

Under-trays fitted obscuring some underside components

Plastic under trays fitteds.

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)