2009 Mazda MX-5

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Headlamp lens slightly defective (4.1.1 (b) (i))

Offside Headlamp has a product on the light source but not seriously reducing light output Dim and poor image (4.1.4 (b))

Offside Headlamp lens slightly defective (4.1.1 (b) (i))

Rear Previous welding repairs to inner sills

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear Suspension arm corroded but not seriously weakened all (5.3.3 (b) (i))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Suspension component mounting repair covered in underseal inner sill (5.3.6 (a) (i))

Offside poor beam image headlamp

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Offside Rear Inner Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced Inner seal structure corroded and holed. (6.1.1 (c) (i))

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement Rear pin bush. (5.3.4 (a) (i))

Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement Rear pin bush. (5.3.4 (a) (i))

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Front brake pads starting to get low

Central Rear Stop lamp(s) non-obligatory stop lamp not working (4.3.1 (a) (ii))

Central Rear Stop lamp(s) non-obligatory stop lamp not working (4.3.1 (a) (ii))

Front Registration plate insecure (0.1 (a))

Central Stop lamp(s) non-obligatory stop lamp not working (4.3.1 (a) (ii))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Tie bar/rod corroded but not seriously weakened all rears (2.4.G.1)

both front and offside rear tyre valves split

centre stop light not working

front and rear inner brake pads low

nearside and offside rear tyres on 3mm

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Driver's seat insecure (6.2.A.1)

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Rear Registration plate lamp not working (1.1.C.1d)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside rear brake fluctuating, but not excessively (3.7.B.3)

Front Brake pad(s) wearing thin (3.5.1g)

Front Brake pad(s) wearing thin (3.5.1g)

Offside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Registration plate lamp not working (1.1.C.1d)

Offside Headlamp not working on dipped beam (1.7.5a)

Front Brake pad(s) wearing thin (3.5.1g)