2018 Peugeot 208

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust fumes causing a danger to health of persons on board exhaust fumes can be smelt inside cabin (6.1.2 (b) (ii)) DANGEROUS

Front Brake disc worn, but not excessively both front discs are slightly worn (1.1.14 (a) (i))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Rear Child Seat fitted not allowing full inspection of adult belt

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Offside Front Headlamp aim unable to be tested (4.1.2 (b))

Offside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge worn edges 195/55r16 (5.2.3 (e))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge worn edges 195/55r16 (5.2.3 (e))

Daytime running lamp not working BOTH (4.2.1 (a) (ii))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust emissions likely to be affected by an exhaust leak Hole at front mounting repair (8.2.2.1 (b))

Nearside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Front Exhaust mounting defective (6.1.2 (a))

Front Suspension arm pin or bush worn but not resulting in excessive movement both sides (5.3.4 (a) (i))

Exhaust mounting defective front (6.1.2 (a))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Brake hydraulic reservoir close to minimum mark (1.1.10 (d) (i))

Front Exhaust mounting defective (6.1.2 (a))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

lower arm bushes perishing but no play osf and nsf

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

lower arm bushes perishing but no play osf and nsf