2004 Mercedes-benz Clk

Offside Front Coil spring fractured or broken (5.3.1 (b) (i))

Headlamp lens slightly defective o/s n/s headlight faded/cloudy (4.1.1 (b) (i))

Nearside Front Lower Suspension arm ball joint excessively worn front arm (5.3.4 (a) (i))

Nearside Front Lower Suspension arm ball joint excessively worn rear arm (5.3.4 (a) (i))

Rear Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Rear Exhaust has a minor leak of exhaust gases back box (6.1.2 (a))

Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Front Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Offside Rear Parking brake inoperative on one side (1.4.1 (a))

Offside Rear Tyre has a tear, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Rear Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Rear Exhaust has a minor leak of exhaust gases back box (6.1.2 (a))

Front Service brake fluctuating, but not excessively slight judder (1.2.1 (e))

Offside Front Lower Anti-roll bar ball joint has slight play (5.3.4 (a) (i))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front Lower Windscreen wiper blade defective (3.4 (b) (i))

Offside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Parking brake lever defective but can be satisfactorily operated cable inside of vehicle not in proper holders but secured in first holder only (1.1.6 (d))

fan belt has small cut/tear on outer side

Offside Rear Inner Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Nearside Front Lower Windscreen wiper blade defective (3.4 (b) (i))

Offside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Parking brake lever defective but can be satisfactorily operated cable inside of vehicle not in proper holders but secured in first holder only (1.1.6 (d))

fan belt has small cut/tear on outer side

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

parking brake poor 18%

Nearside Rear coil spring broken (2.4.C.1a)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

parking brake poor 18%

Nearside wiper rubber just meets requiremants

Offside Rear wheel slight binding

headlight beam patterns poor

parking brake poor at 18%

Engine covers fitted obscuring some components in the engine bay

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Under-trays fitted obscuring some underside components

rear wheels noisy when checking suspect parking brake shoes

Engine covers fitted obscuring some components in the engine bay

Under-trays fitted obscuring some underside components

noise n/s/r wheel suspect handbrake shoes/rusty disc.parking brake lazy on this wheel recommend further investgation

Centre Front Upper Windscreen has a sticker or other obstruction encroaching into the swept area by more than 40mm outside zone 'A' (8.3.1e)

Offside Headlamp aim too high (1.8)

n/s/f tyre wearing on outer edge also damage outer wall

parking brake release slightly sticking

both front lower suspension arm bushes in very poor condition no play at time of test

n/s/f tyre wearing on outer edge also damage outer wall

parking brake release slightly sticking

both front lower suspension arm bushes in very poor condition no play at time of test

Nail in nearside rear tyre

Nearside Front Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

Nearside Headlamp not working on dipped beam (1.7.5a)

Windscreen has damage to an area in excess of a 10mm circle within zone 'A' (8.3.1a)