MOT Status
ExpiredMileage
93,517 miSignificantly above average — investigate
Not all car check providers offer a guarantee. Don't risk buying from services that can't back their data. CarVerify reports include a £30,000 finance data guarantee.
Vehicle Details
All premium checks include
50+ data pointsMOT History
Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))
Exhaust has a major leak of exhaust gases (6.1.2 (a))
Exhaust system insecure (6.1.2 (a))
Nearside Front Anti-roll bar ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))
Nearside Front Suspension arm pin or bush excessively worn (5.3.4 (a) (i))
Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sil (5.3.6 (a) (i))
Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sil (5.3.6 (a) (i))
Offside Front Suspension arm pin or bush excessively worn (5.3.4 (a) (i))
Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength near brake flexi support bracket (5.3.6 (a) (i))
Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sil (5.3.6 (a) (i))
Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sil (5.3.6 (a) (i))
Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))
Offside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS
n/s/f wing held on with tape
n/s/r tyre cracking
rear suspension springs surface corrosion
various parts and places have surface corrosion
Exhaust has a minor leak of exhaust gases (6.1.2 (a))
Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))
Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))
Oil leak, but not excessive (8.4.1 (a) (i))
Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill (5.3.6 (a) (i))
Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill (5.3.6 (a) (i))
Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))
Exhaust has a minor leak of exhaust gases (6.1.2 (a))
Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))
Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))
Oil leak, but not excessive (8.4.1 (a) (i))
Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))
Nearside Front Brake disc significantly and obviously worn (1.1.14 (a) (i))
Nearside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))
Offside Front Brake disc significantly and obviously worn (1.1.14 (a) (i))
Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill (5.3.6 (a) (i))
Offside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))
Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))
Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))
Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))
Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive inner arch (5.3.6 (a) (i))
Nearside Suspension component mounting prescribed area is corroded but not considered excessive floor to sill (5.3.6 (a) (i))
Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))
Offside Front Suspension component mounting prescribed area is corroded but not considered excessive inner arch (5.3.6 (a) (i))
Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive chassis leg (5.3.6 (a) (i))
Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))
Offside Suspension component mounting prescribed area is corroded but not considered excessive floor to sill (5.3.6 (a) (i))
Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))
Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive chassis leg (5.3.6 (a) (i))
Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))
Offside Front Suspension component mounting prescribed area is corroded but not considered excessive chassis leg (5.3.6 (a) (i))
Brake fluid close to minimum mark (1.1.10 (d) (ii))
Fuel filter insecure and corroded.
Nearside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))
Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement Rear mounting bush (5.3.4 (a) (i))
Offside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))
Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement Rear mounting bush (5.3.4 (a) (i))
Nearside Rear Suspension component mounting prescribed area is excessively corroded inner sill (2.4.A.3)
Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)
Offside Stop lamp not working (1.2.1b)
Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive inner sill (2.4.A.3)
Nearside Front Road wheel with a slightly distorted bead rim (4.2.A.1a)
Nearside Front Tyre worn close to the legal limit (4.1.E.1)
Nearside Rear Sub-frame rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)
Nearside Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)
Offside Front Road wheel with a slightly distorted bead rim (4.2.A.1a)
Offside Front Tyre worn close to the legal limit (4.1.E.1)
Offside Headlamp aim too high (1.8)
Offside Headlamp not working on dipped beam (1.7.5a)
Offside Rear Sub-frame rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)
Oil leak
Nearside Front Road wheel with a slightly distorted bead rim (4.2.A.1a)
Nearside Front Tyre worn close to the legal limit (4.1.E.1)
Nearside Rear Sub-frame rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)
Nearside Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)
Offside Front Road wheel with a slightly distorted bead rim (4.2.A.1a)
Offside Front Tyre worn close to the legal limit (4.1.E.1)
Offside Rear Sub-frame rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)
Oil leak
Nearside Headlamp aim too low and too far to the right. (1.8)
Registration plate lamp not working (1.1.C.1d)
Nearside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)
Offside Front Upper Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)
front brake discs wearing thin
front tyres scrubbed on inner edges
Front Brake pad(s) less than 1.5 mm thick (3.5.1g)
Registration plate lamp not working (1.1.C.1d)
How Reliable is the Ford Ka?
Based on 8,818,307 MOT tests across 675,715 vehicles.
Top MOT Failure Points
Don't risk it. Know before you buy.
Not all vehicle check providers are the same. Some don't offer a data guarantee, which means if their information is wrong, you're on your own. Every CarVerify report is backed by a £30,000 finance data guarantee.
KS57 CNC is a 2008 Ford Ka in Grey with a 1,299cc petrol engine. This vehicle has been through 21 MOT tests with a personal pass rate of 66.7%.
Across all 2008 Ford Ka models, the average MOT pass rate is 71.0% with a typical mileage of 41,756 miles. This particular vehicle has a lower pass rate than the average for its year, which may indicate maintenance issues worth investigating.
The most common reason a Ford Ka fails its MOT is suspension component mounting prescribed area is excessively corroded, accounting for 404,005 recorded failures. If you're considering buying KS57 CNC, it's worth having these areas checked by a mechanic before committing.
The Ford Ka typically stays on UK roads for around 29 years. At 18 years old, this Ford Ka is well into its expected lifespan but still has years ahead.
Frequently Asked Questions
How do I check the history of KS57 CNC?
You can check the full history of KS57 CNC by running a full vehicle check. This shows you finance, stolen, write-off, MOT history, mileage records and more.
What year was KS57 CNC registered?
KS57 CNC is a 2008 Ford Ka, first registered on 31 January 2008.
Is KS57 CNC safe to buy?
The MOT history for KS57 CNC shows 21 tests with a 66.7% pass rate. To check for outstanding finance, stolen markers, write-off history and mileage discrepancies, run a full vehicle check.
Does KS57 CNC have outstanding finance?
Finance checks require a premium vehicle report. This checks against all major UK finance providers to see if there is any outstanding finance on KS57 CNC. If you buy a car with outstanding finance, the finance company can repossess it.
No warranty or guarantee of accuracy is provided for any free data on this page. The data guarantee applies only to information obtained through the purchase of a full check.