2006 Chevrolet Matiz

Offside Rear Wheel bearing slightly noisy (5.1.3 (b) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Front Oil leak, but not excessive (8.4.1 (a) (i))

Front Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Rear Coil spring corroded (5.3.1 (b) (i))

Rear Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Front Oil leak, but not excessive (8.4.1 (a) (i))

Front Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Front Windscreen washer not working (3.5 (a))

Rear Coil spring corroded (5.3.1 (b) (i))

Rear Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Brake pipe corroded, covered in grease or other material Both front to rear by flex hoses (1.1.11 (c))

Front & rear suspension components, rust corrosion

Front Headlamp lens, little worn

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Inner Tyre worn close to legal limit/worn on edge 165/65/13 (5.2.3 (e))

Oil leak, but not excessive Engine (8.4.1 (a) (i))

Rear Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Rear Brake hose slightly deteriorated Both (1.1.12 (b) (ii))

Rear Brakes are lightly binding on u/l, both

Nearside Front Headlamp aim too low (4.1.2 (a))

Nearside Front Lower Suspension arm ball joint excessively worn Outer (5.3.4 (a) (i))

Nearside Front Outer Road wheel badly distorted S (5.2.2 (c) (i))

Nearside Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Nearside Rear Lower Seat belt anchorage prescribed area strength or continuity significantly reduced outer SILL PANEL (7.1.1 (a) (i))

Offside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Front Lower Seat belt anchorage prescribed area strength or continuity significantly reduced outer SILL PANEL (7.1.1 (a) (i))

Offside Front Lower Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer SILL PANEL (5.3.6 (a) (i))

Offside Rear Lower Seat belt anchorage prescribed area strength or continuity significantly reduced outer SILL PANEL (7.1.1 (a) (i))

Rear Lower Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer SILL PANELS, BOTH (5.3.6 (a) (i))

Nearside Front Tyre tread depth below requirements of 1.6mm 165/65/13 (5.2.3 (e)) DANGEROUS

Brake pipe corroded, covered in grease or other material Both front to rear by flex hoses (1.1.11 (c))

Front & rear suspension components, rust corrosion

Front Headlamp lens, little worn

Front Tracking is out

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Inner Tyre worn close to legal limit/worn on edge 165/65/13 (5.2.3 (e))

Oil leak, but not excessive Engine (8.4.1 (a) (i))

Rear Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Rear Brake hose slightly deteriorated Both (1.1.12 (b) (ii))

Rear Brakes are lightly binding on u/l, both

Offside Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Offside Rear Axle swivel pins and bushes swivel pin and/or bush slightly worn (5.1.2 (b) (i))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust has a major leak of exhaust gases (6.1.2 (a))

Nearside Front Seat belt buckle not functioning as intended (7.1.2 (d))

Nearside Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Oil leaking excessively from engine (8.4.1 (a) (i))

Offside Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Offside Rear Axle swivel pins and bushes swivel pin and/or bush slightly worn (5.1.2 (b) (i))

Nearside Front Front position lamp(s) not working (1.1.A.3b)

alingment front tracking needs looking at

oil leaking from engine

Nearside Front Tyre tread depth below requirements of 1.6mm worn below 1.6mm inside edge 155/65/r13 73t (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm worn below 1.6mm inside edge (4.1.E.1)

alingment front tracking needs looking at

oil leaking from engine

Front Brake pad(s) wearing thin (3.5.1g)

Nail in nearside rear tyre

front tyres wearing on edge