2007 Lexus IS250

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content at idle exceeds manufacturer's specified limits (8.2.1.2 (b))

Exhaust hydrocarbon content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Rear Wheel bearing rough when rotated (5.1.3 (b) (i))

Offside Front Body component damaged and likely to cause injury Door (6.2.1 (a) (i))

Offside Front Seat belt buckle not functioning as intended (7.1.2 (d))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Rear Wheel bearing rough when rotated (5.1.3 (b) (i))

Offside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside rear wheel arch corroded

Front Tyre worn close to legal limit/worn on edge both (5.2.3 (e))

Nearside Rear Shock absorbers has light misting of oil (5.3.2 (b))

Offside Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Parking brake inoperative on one side very low (1.4.1 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Front Tyre worn close to legal limit/worn on edge both (5.2.3 (e))

Nearside Rear Shock absorbers has light misting of oil (5.3.2 (b))

Offside Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Rear Wheel bearing slightly noisy (5.1.3 (b) (i))

Electronic stability control warning lamp indicates a fault (7.12 (e))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Front Shock absorbers has a serious fluid leak (5.3.2 (b))

Nearside Rear Wheel bearing slightly noisy (5.1.3 (b) (i))

handbrake lever has travel

Front Sub-frame is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Front Suspension component ball joint has slight play both (5.3.4 (a) (i))

Road wheel slightly distorted all four (5.2.2 (c) (i))

Electronic stability control warning lamp indicates a fault (7.12 (e))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Front Position lamp not working (4.2.1 (a))

Nearside Rear Registration plate lamp does not illuminate simultaneously with the position lamps (4.7.2 (a))

Offside Front Position lamp not working (4.2.1 (a))

Offside Rear Registration plate lamp does not illuminate simultaneously with the position lamps (4.7.2 (a))

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Road wheel slightly distorted all four (5.2.2 (c) (i))

engine management light on

n/s/f tyre wearing on edges and damage to outer sidewall

n/s/r tyre damage to outer sidewall

o/s/f tyre wearing on edges and damage to outer sidewall

o/s/r tyre wearing on inner edge and damage to outer sidewall

traction control light on

Nearside Front Wheel nut(s) missing (4.2.A.1e)

Nearside Rear Wheel nut(s) missing (4.2.A.1e)

Offside Front Wheel nut(s) missing (4.2.A.1e)

Offside Rear Wheel nut(s) missing (4.2.A.1e)

n/s/r tyre damage to outer sidewall

engine management light on

n/s/f tyre wearing on edges and damage to outer sidewall

o/s/f tyre wearing on edges and damage to outer sidewall

o/s/r tyre wearing on inner edge and damage to outer sidewall

traction control light on

Advise front tyres worn on inner edge