2012 Vauxhall Insignia

All direction indicators slightly discoloured (4.4.3 (a))

Exhaust flexi deteriorated

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Nearside Front Shock absorbers has light misting of oil (5.3.2 (b))

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Front Anti-roll bar linkage ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Front Shock absorbers has light misting of oil (5.3.2 (b))

Offside Rear Tyre worn close to legal limit/worn on edge cracking or perishing (5.2.3 (e))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Boot lid cannot be secured in the closed position (6.2.1 (e))

Front Exhaust has a major leak of exhaust gases flexible section (6.1.2 (a))

Nearside Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Nearside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Nearside Front tyre tread worn on outer edge

Nearside Front Shock absorbers light misting of oil or has limited damping effect SLIGHT LEAK (5.3.2 (b))

Nearside Rear Nail in tyre ()

Nearside Rear Tyre worn close to legal limit/worn on edge 245/45R18 (5.2.3 (e))

Offside Front Shock absorbers light misting of oil or has limited damping effect SLIGHT LEAK (5.3.2 (b))

Engine management light on

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre has a lump, caused by separation or partial failure of its structure (4.1.D.1b) DANGEROUS

Engine management light on

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Shock absorber has a light misting of oil (2.7.3)

Offside Front Shock absorber has a light misting of oil (2.7.3)

Tyre tread depth below requirements of 1.6mm (4.1.E.1)