MOT Status
ExpiredMileage
168,467 miSignificantly above average — investigate
Not all car check providers offer a guarantee. Don't risk buying from services that can't back their data. CarVerify reports include a £30,000 finance data guarantee.
Vehicle Details
All premium checks include
50+ data pointsMOT History
Engine MIL inoperative or indicates a malfunction (8.2.2.2 (g))
Exhaust emissions exceed manufacturer's specified limit (8.2.2.2 (a))
Front Fuel system component leaking (6.1.3 (b) (i))
Nearside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))
Nearside Rear Stop lamp(s) not working (4.3.1 (a) (ii))
Offside Front Headlamp aim too low (4.1.2 (a))
Offside Front Lower Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))
Offside Front Windscreen washer jets misaligned and not providing sufficient fluid to the windscreen pipe broken (3.5 (a))
Rear fog lamp not working (4.5.1 (a) (ii))
Exhaust emits excessive smoke or vapour likely to obscure the vision of other road users (8.2.2.2 (c)) DANGEROUS
Offside Rear Tyre has a tear, caused by separation or partial failure of its structure inner edge (5.2.3 (d) (ii)) DANGEROUS
Front Registration plate deteriorated but not likely to be misread (0.1 (b))
Front n/s & o/s out riggers corroded
Offside Exhaust has a minor leak of exhaust gases rear pipe corroded holed (6.1.2 (a))
Both Front jacking areas slightly corroded
Engine management light illuminated - Pre 2008
Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))
Front Registration plate deteriorated but not likely to be misread (0.1 (b))
Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))
Oil leak, but not excessive (8.4.1 (a) (i))
Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))
Rear Registration plate deteriorated but not likely to be misread (0.1 (b))
Rear exhaust corroded
Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))
Rear fog lamp not working (4.5.1 (a) (ii))
Both Front jacking areas slightly corroded
Engine management light illuminated - Pre 2008
Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))
Front Registration plate deteriorated but not likely to be misread (0.1 (b))
Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))
Oil leak, but not excessive (8.4.1 (a) (i))
Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))
Rear Registration plate deteriorated but not likely to be misread (0.1 (b))
Rear exhaust corroded
EML and glow plug lamps illuminated.
Exhaust has a minor leak of exhaust gases Exhaust down pipe clamp missing (System still secure). (6.1.2 (a))
Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))
Front Registration plate deteriorated but not likely to be misread (0.1 (b))
Indicator switch insecure (4.4.2 (a) (i))
Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))
Nearside Front Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))
Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))
Offside Front Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))
Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))
Rear Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))
Nearside Front Lower Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))
Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))
Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))
Offside Front Brake pipe excessively corroded (1.1.11 (c))
Offside Front Lower Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))
Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))
Offside Rear Brake pipe excessively corroded (1.1.11 (c))
EML and glow plug lamps illuminated.
Exhaust has a minor leak of exhaust gases Exhaust down pipe clamp missing (System still secure). (6.1.2 (a))
Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))
Front Registration plate deteriorated but not likely to be misread (0.1 (b))
Indicator switch insecure (4.4.2 (a) (i))
Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))
Nearside Front Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))
Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))
Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))
Offside Front Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))
Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))
Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))
Rear Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))
Front Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))
Indicator switch insecure (4.4.2 (a) (i))
Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))
Nearside Integral body structure is corroded but structural rigidity is not significantly reduced jackng point (6.1.1 (c) (i))
Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))
Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))
Offside Front Tyre has a cut but not deep enough to reach the ply or cords (5.2.3 (d) (i))
Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))
Offside Integral body structure is corroded but structural rigidity is not significantly reduced jacking point (6.1.1 (c) (i))
Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))
Power steering pipe/hose slightly corroded (2.1.5 (g) (i))
Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))
Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))
Parking brake lever has excessive movement indicating incorrect adjustment (1.1.6 (c))
Front Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))
Indicator switch insecure (4.4.2 (a) (i))
Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))
Nearside Integral body structure is corroded but structural rigidity is not significantly reduced jackng point (6.1.1 (c) (i))
Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))
Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))
Offside Front Tyre has a cut but not deep enough to reach the ply or cords (5.2.3 (d) (i))
Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))
Offside Integral body structure is corroded but structural rigidity is not significantly reduced jacking point (6.1.1 (c) (i))
Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))
Power steering pipe/hose slightly corroded (2.1.5 (g) (i))
Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))
Nearside Front Subframe mounting prescribed area is corroded but not considered excessive Rear mount jacking point (5.3.6 (a) (i))
Nearside Rear Brake pipe corroded, covered in grease or other material Corroded (1.1.11 (c))
Offside Front Subframe mounting prescribed area is corroded but not considered excessive Rear mount jacking point (5.3.6 (a) (i))
Offside Rear Brake pipe corroded, covered in grease or other material Corroded (1.1.11 (c))
Park brake has little reserve travel
Offside Rear light lens cracking
Central Exhaust has a major leak of exhaust gases (6.1.2 (a))
Offside Headlamp aim too high (4.1.2 (a))
Nearside Front Brake disc worn, but not excessively (1.1.14 (a) (i))
Nearside Headlamp lens slightly defective (4.1.1 (b) (i))
Offside Front Brake disc worn, but not excessively (1.1.14 (a) (i))
Offside Headlamp lens slightly defective (4.1.1 (b) (i))
auxiliary drivebelt perished
Nearside Front Brake disc worn, but not excessively (1.1.14 (a) (i))
Nearside Headlamp lens slightly defective (4.1.1 (b) (i))
Offside Front Brake disc worn, but not excessively (1.1.14 (a) (i))
Offside Front Position lamp not working (4.2.1 (a))
Offside Headlamp lens slightly defective (4.1.1 (b) (i))
auxiliary drivebelt perished
offside front tyre worn on outer edge
front brake flex hoses perished
Nearside Front Brake hose slightly deteriorated (3.6.B.4d)
Offside Front Brake hose slightly deteriorated (3.6.B.4d)
Front brake flexi hoses perished
Front discs lipped
Front pads getting low
Parking brake lever has little reserve travel (3.1.6b)
Parking brake lever has little reserve travel (3.1.6b)
stone chip in screen
Offside Registration plate lamp not working (1.1.C.1d)
Offside Obligatory mirror seriously damaged, affecting the rear view (8.1.2a) DANGEROUS
Parking brake lever has little reserve travel (3.1.6b)
stone chip in screen
Nearside Rear Tyre worn close to the legal limit (4.1.E.1)
Offside Rear Tyre worn close to the legal limit (4.1.E.1)
Rear Exhaust has a major leak of exhaust gases (7.1.2)
Nearside Rear Tyre worn close to the legal limit (4.1.E.1)
Offside Rear Tyre worn close to the legal limit (4.1.E.1)
PARKING BRAKE (LONG TRAVEL)
STONE CHIP IN WINDSCREEN LESS THAN 40MM IN ZONE B
How Reliable is the Mercedes-benz Vito?
Based on 2,011,702 MOT tests across 164,434 vehicles.
Top MOT Failure Points
Don't risk it. Know before you buy.
Not all vehicle check providers are the same. Some don't offer a data guarantee, which means if their information is wrong, you're on your own. Every CarVerify report is backed by a £30,000 finance data guarantee.
KU55 GZP is a 2005 Mercedes-benz Vito in White with a 2,148cc diesel engine. This vehicle has been through 25 MOT tests with a personal pass rate of 68%.
Across all 2005 Mercedes-benz Vito models, the average MOT pass rate is 68.7% with a typical mileage of 113,960 miles. This particular vehicle has a lower pass rate than the average for its year, which may indicate maintenance issues worth investigating.
The most common reason a Mercedes-benz Vito fails its MOT is parking brake: efficiency below requirements, accounting for 49,564 recorded failures. If you're considering buying KU55 GZP, it's worth having these areas checked by a mechanic before committing.
The Mercedes-benz Vito typically stays on UK roads for around 29 years. At 21 years old, this Mercedes-benz Vito is well into its expected lifespan but still has years ahead.
Frequently Asked Questions
How do I check the history of KU55 GZP?
You can check the full history of KU55 GZP by running a full vehicle check. This shows you finance, stolen, write-off, MOT history, mileage records and more.
What year was KU55 GZP registered?
KU55 GZP is a 2005 Mercedes-benz Vito, first registered on 16 November 2005.
Is KU55 GZP safe to buy?
The MOT history for KU55 GZP shows 25 tests with a 68% pass rate. To check for outstanding finance, stolen markers, write-off history and mileage discrepancies, run a full vehicle check.
Does KU55 GZP have outstanding finance?
Finance checks require a premium vehicle report. This checks against all major UK finance providers to see if there is any outstanding finance on KU55 GZP. If you buy a car with outstanding finance, the finance company can repossess it.
No warranty or guarantee of accuracy is provided for any free data on this page. The data guarantee applies only to information obtained through the purchase of a full check.