2008 Saab 9-5

all under body corroded

oil leak

rear brakes binding

Oil leak, but not excessive (8.4.1 (a) (i))

Central Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front Sub-frame corroded but not seriously weakened and suspension components (5.3.3 (b) (i))

Rear Sub-frame corroded but not seriously weakened and suspension components (5.3.3 (b) (i))

Nearside Rear Rear reflector missing (4.8.2 (a) (ii))

Offside Rear Rear reflector missing (4.8.2 (a) (ii))

Oil leaking excessively from engine (8.4.1 (a) (i))

Central Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front Sub-frame corroded but not seriously weakened and suspension components (5.3.3 (b) (i))

Nearside Headlamp aim too low (4.1.2 (a))

Offside Headlamp aim too low (4.1.2 (a))

Rear Sub-frame corroded but not seriously weakened and suspension components (5.3.3 (b) (i))

Central Exhaust mounting defective missing (6.1.2 (a))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Sub-frame pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))

Offside Front Sub-frame pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Offside Rear Rear fog lamp not working (4.5.1 (a) (ii))

Central Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Central Exhaust mounting defective missing (6.1.2 (a))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Sub-frame pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))

Offside Front Sub-frame pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Central Exhaust emissions likely to be affected by an exhaust leak (8.2.2.1 (b))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Nearside Front Sub-frame pin or bush excessively worn (5.3.4 (a) (i))

Rear fog lamp not working (4.5.1 (a) (ii))

General corrosion to structure and suspension components under vehicle

Offside Front Sub-frame pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Front Coil spring corroded (5.3.1 (b) (i))

Central Exhaust has a major leak of exhaust gases (6.1.2 (a))

Rear Brakes imbalanced across an axle (1.2.1 (b) (i))

Nearside Front Brake hose ferrule excessively corroded and likely to fail (1.1.12 (f) (ii)) DANGEROUS

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Nearside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Front Brake hose ferrule excessively corroded and likely to fail (1.1.12 (f) (ii)) DANGEROUS

Front Coil spring corroded (5.3.1 (b) (i))

Offside Front Tyre worn close to legal limit/worn on edge 2.0mm (5.2.3 (e))

Rear Brake pipe corroded, covered in grease or other material both (1.1.11 (c))

Rear Coil spring corroded (5.3.1 (b) (i))

Front Exhaust has a minor leak of exhaust gases flexi (6.1.2 (a))

Nearside Rear Tyre slightly damaged side wall (5.2.3 (d) (ii))

Nearside Rear Upper Suspension arm pin or bush worn but not resulting in excessive movement radius arm (5.3.4 (a) (i))

Offside Front Lower Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front Vehicle structure is corroded but structural rigidity is not significantly reduced subframe (6.1.1 (c) (i))

Offside Front Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Rear light leveling sensor linkage broken

Front Vehicle structure is corroded but structural rigidity is not significantly reduced subframe (6.1.1 (c) (i))

Nearside Headlamp aim too low (4.1.2 (a))

Offside Front Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Headlamp aim too low (4.1.2 (a))

Rear light leveling sensor linkage broken

Front Sub-frame corroded but not seriously weakened (2.4.G.1)

Nearside Front Brake hose has slight corrosion to ferrules (3.6.B.4e)

Offside Front Brake hose has slight corrosion to ferrules (3.6.B.4e)

Nearside Front position lamp(s) not working (1.1.A.3b)

Offside Rear Mechanical brake component locking device missing caliper securing clip (3.5.1l) DANGEROUS

Front Sub-frame corroded but not seriously weakened (2.4.G.1)

Nearside Front Brake hose has slight corrosion to ferrules (3.6.B.4e)

Offside Front Brake hose has slight corrosion to ferrules (3.6.B.4e)

Nearside front brake fluctuating, but not excessively (3.7.B.3)

Offside front brake fluctuating, but not excessively (3.7.B.3)

nearside rear upper suspension arm outer bush worn

rear parking (secondary) brake imbalance requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.6b)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake lever has no reserve travel (3.1.6b)

Parking brake: efficiency below requirements (3.7.B.7)

Nearside front brake fluctuating, but not excessively (3.7.B.3)

Offside front brake fluctuating, but not excessively (3.7.B.3)

nearside rear upper suspension arm outer bush worn

rear exhaust poor condition

Nearside Front position lamp(s) not working (1.1.A.3b)

Offside Front position lamp(s) not working (1.1.A.3b)

rear exhaust poor condition

Rear exhaust cylancer is coroded

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Bonnet cannot be secured in the closed position (8.4.1)

Front registration plate delaminated (6.3.1d)

Nearside Rear Tyre has a lump, caused by separation or partial failure of its structure (4.1.D.1b)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

O/S/R tyre 2mm and slightly out of shape

Parking brake lever has no reserve travel (3.1.6b)

Parking brake: efficiency below requirements (3.7.C.1b)