2012 Ford Ranger

Brake pipe corroded, covered in grease or other material All front to rear /front sections (1.1.11 (c))

Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security All rear (6.2.2 (d) (i))

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Electronic stability control warning lamp indicates a fault (7.12 (e))

Nearside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Nearside Outer Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced Sill (6.1.1 (c) (i))

Offside Front Steering rack gaiter missing or no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Outer Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced Sill (6.1.1 (c) (i))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Brake pipe corroded, covered in grease or other material All brake pipes (1.1.11 (c))

Front Cab or chassis corroded within 30cm of a mounting, but not seriously affecting overall security Front crash bar (6.2.2 (d) (i))

Headlamp aim not tested (1.8.A.1c)

Nearside Headlamp not working on dipped beam (1.7.5a)

Nearside Headlamp not working on main beam (1.7.5a)

Offside Headlamp not working on dipped beam (1.7.5a)

Offside Headlamp not working on main beam (1.7.5a)

Offside Stop lamp not working (1.2.1b)

Headlamp aim too high both (1.8)

Nearside Outer Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Registration plate lamp not working (1.1.C.1d)

Nearside Windscreen wiper blade missing (8.2.2) DANGEROUS

eml iluuminated

rear tyres different size to front both

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

Registration plate lamp not working both sides (1.1.C.1d)

Windscreen wiper does not clear the windscreen effectively both sides (8.2.2)