2008 Ford Ka

Front Suspension component mounting prescribed area is corroded but not considered excessive both sides inner sills / floor (5.3.6 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive both sides inner sills / floor (5.3.6 (a) (i))

Brake hydraulic reservoir close to minimum mark (1.1.10 (d) (i))

Front Suspension component mounting prescribed area is corroded but not considered excessive both sides inner wings (5.3.6 (a) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive both sides sills / floor (5.3.6 (a) (i))

Offside Front Coil spring fractured or broken (5.3.1 (b) (i))

Offside Front Tyre tread depth below requirements of 1.6mm 165/60/14 (5.2.3 (e)) DANGEROUS

Brake hydraulic reservoir close to minimum mark (1.1.10 (d) (i))

Front Suspension component mounting prescribed area is corroded but not considered excessive both sides inner wings (5.3.6 (a) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive both sides sills / floor (5.3.6 (a) (i))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Exhaust carbon monoxide content at idle exceeds default limits (8.2.1.2 (b))

Offside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Nearside Front Suspension arm ball joint has slight play (5.3.4 (a) (i))

Nearside Rear Rear position lamp(s) not working (1.1.A.3b)

Offside Rear Tyre has a tear, caused by separation or partial failure of its structure (4.1.D.1b)

Nearside Rear Radius arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Offside Front Inner Suspension arm rubber bush bonding deteriorated resulting in excessive movement REAR (2.4.G.2)

Front Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Rear Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

underside corroded in places

front brakes release unevenly (3.7.B.4)

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Rear Rear position lamp(s) not working (1.1.A.3b)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

underside corroded in places

Offside Inner Rear Suspension spring mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Front Headlamp aim too low (1.8)