2010 Honda Anf

Front wheel bearing slightly rough when rotated

Rear lamp cracked

Rear wheel slightly buckled

Steering headbearing slightly stiff or notchy (2.2.2 (f) (i))

oil leak

Rear Position lamp not working (4.2.1 (a))

Stop lamp remains on when the brakes are released Front lever (4.3.2 (a) (iii)) DANGEROUS

Front wheel bearing slightly rough when rotated

Rear lamp cracked

Rear wheel slightly buckled

Steering headbearing slightly stiff or notchy (2.2.2 (f) (i))

oil leak

slight oil leak from LH side casing

Steering headbearing slightly stiff or notchy (2.2.2 (f) (i))

Wheel alignment slightly misaligned (2.4 (a))

rear wheel slightly buckled

Headlamp aim too low (4.1.2 (a))

Headlamp insecure (4.1.1 (c))

Front Direction indicator insecure both (4.4.1 (c) (i))

Steering headbearing slightly stiff or notchy (2.2.2 (f) (i))

Wheel alignment slightly misaligned (2.4 (a))

rear wheel slightly buckled

slight oil leak from LH side casing

Front Headlamp insecure (4.1.1 (c))

Nearside Rear Footrest missing (6.2.12 (a))

Offside Rear Footrest missing (6.2.12 (a))

Rear Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Rear Wheel bearing has excessive play (5.1.3 (a) (i))

Steering headbearing has excessive wear or free play (2.2.2 (f) (i))

Stop lamp does not illuminate by the operation of both brake controls front brake switch (4.3.2 (a) (iii)) DANGEROUS

Drive chain slightly tight (6.1.7 (k) (i))

Rear drive chain guard missing

Front Stop lamp switch does not operate in accordance with the requirements (4.3.2 (a) (i))

Front Brake disc significantly and obviously worn (1.1.14 (a) (i))

Headlamp aim too low (4.1.2 (a))

Headlamp insecure (4.1.1 (c))

Front Stop lamp switch does not operate in accordance with the requirements (4.3.2 (a) (i))

Drive chain excessively loose (6.2.1d)

Offside Front shock absorber seal failed and leaking oil (2.3.3)

Steering headbearing has excessive free play (2.2.2)

Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Front Tyre worn close to the legal limit (4.1.3(ii))

Front suspension has a slightly reduced damping effect (2.3.6c)

Front Brake disc(s) slightly worn (3.2.A1l)

Offside Brake lever is short but brake can still be readily applied (3.1.3c)

Brake pedal has inadequate reserve travel (3.1.3b)

Drive chain excessively loose (6.2.1d)

Front Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))

Stop lamp remains on when the brake is released (1.3.1e)

Front Brake disc(s) slightly worn (3.2.A1l)

Offside Brake lever is short but brake can still be readily applied (3.1.3c)