2007 Mercedes-benz Vito

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Nearside Front Lower Suspension arm ball joint has slight play (5.3.4 (a) (i))

Nearside Front Track rod end ball joint has slight play (2.1.3 (b) (i))

Nearside Rear Wheel arch corroded but not likely to cause injury

Offside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Lower Suspension arm ball joint has slight play (5.3.4 (a) (i))

Offside Headlamp lens slightly defective (4.1.1 (b) (i))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Inner Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Rear Wheel arch corroded but not likely to cause injury

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Electronic stability control warning lamp indicates a fault (7.12 (e))

Nearside Front Lower Suspension component ball joint excessively worn (5.3.4 (a) (i))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Headlamp aim projected beam image is obviously incorrect DIP BEAM BULB NOT LOCATED CORRECTLY (4.1.2 (c))

Nearside Rear Position lamp not working (4.2.1 (a) (ii))

Offside Front Anti-roll bar linkage insecurely attached LINK ROD (5.3.3 (a) (i))

Offside Front Direction indicator incorrect colour SHOWS WHITE (4.4.3 (a))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength CHASSIS CROSSMEMBER NEAR REAR SPRING [OFFSIDE] (5.3.6 (a) (i))

Offside Rear fog lamp not working (4.5.1 (a) (ii))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Rear Registration plate deteriorated but not likely to be misread reg plate fading /deteriorated (0.1 (b))

Brake fluid warning lamp illuminated (3.6.G.2)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Front Headlamp not working on dipped beam (1.7.5a)

Nearside Front Suspension arm has excessive play in a ball joint (2.4.G.2)

Nearside Front Track rod end ball joint has excessive play (2.2.B.1f)

Parking brake: efficiency below requirements (3.7.B.7)

Suspension component mounting prescribed area is excessively corroded rear chassis rail (2.4.A.3)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Oil leak fron and rear ()

Parking brake lever has little reserve travel all new on rear (3.1.6b)

Rear Brake pad(s) wearing thin (3.5.1g)

Parking brake lever has no reserve travel (3.1.6b)

Parking brake: efficiency below requirements (3.7.B.7)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Oil leak fron and rear ()

Rear Brake pad(s) wearing thin (3.5.1g)

brake pad warning light on

Nearside Front Tyre has ply or cords exposed (4.1.D.1b) DANGEROUS

brake pad warning light on

nearside front tyre on limit

Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Parking brake lever has no reserve travel (3.1.6b)

Nearside Drag link end ball joint has slight play (2.2.B.1f)