2013 Peugeot 208

Front Brake disc worn, pitted or scored, but not seriously weakened both sides (1.1.14 (a) (ii))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

undersealed

Front Brake disc worn, pitted or scored, but not seriously weakened both sides (1.1.14 (a) (ii))

Nearside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

undersealed

Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Front Brake disc worn, but not excessively (1.1.14 (a) (i))

Nearside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Brake disc worn, but not excessively (1.1.14 (a) (i))

Offside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Front Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Vehicle structure is corroded but structural rigidity is not significantly reduced axle (6.1.1 (c) (i))

Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Front Brake disc worn, but not excessively (1.1.14 (a) (i))

Nearside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Headlamp aim too low (4.1.2 (a))

Nearside Front Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Brake disc worn, but not excessively (1.1.14 (a) (i))

Offside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Front Headlamp aim too low (4.1.2 (a))

Offside Front Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Vehicle structure is corroded but structural rigidity is not significantly reduced axle (6.1.1 (c) (i))

Nearside Rear Wheel bearing slightly noisy (5.1.3 (b) (i))

Emissions not tested exhaust leaking (8.2.1.2 (d))

Front Exhaust has a major leak of exhaust gases (6.1.2 (a))

Offside Rear Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Nearside Rear Wheel bearing slightly noisy (5.1.3 (b) (i))

Emissions not tested exhaust leaking (8.2.1.2 (d))

Front Exhaust has a major leak of exhaust gases (6.1.2 (a))

Nearside Front Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Front Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Front Headlamp aim too high (4.1.2 (a))

Offside Front Service brake excessively binding (1.2.1 (f))

Nearside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Nearside Front Headlamp aim too high (1.8)

Offside Front Headlamp aim too high (1.8)

Rear Exhaust system not adequately supported (7.1.1)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

offside rear tyre has slight damage to inner side wall