2007 Aprilia RS125

Rear Lower Suspension rod pin, bush or joint worn but not resulting in excessive movement (5.3.4 (a) (i))

slight cracking in tread rear tyre

Rear Lower Suspension rod pin or bush excessively worn (5.3.4 (a) (i))

Rear Wheel bearing has excessive play (5.1.3 (a) (i))

slight cracking in tread rear tyre

Clutch lever shortened. (6.2.1g)

Fairing insecure but not likely to impede the steering (2.1.2e)

left switch gear slightly insecure

light binding on front brake,

Clutch lever shortened. (6.2.1g)

Fairing insecure but not likely to impede the steering (2.1.2e)

Front Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Rear reflector on motorcycle does not reflect squarely to the rear (1.4.1)

left switch gear slightly insecure

light binding on front brake,

Rear Drive chain slightly loose (6.2.1d)

Side stand switch u/s

Front Headlamp aim too low (1.6)

Rear Drive chain slightly loose (6.2.1d)

Side stand switch u/s

Centre Rear Rear position lamp does not illuminate immediately when it is switched on (1.1.3a)

Front Roller brake test indicates a binding brake (3.3.A1a)

Front Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))

Nearside Front Upper Handlebar deformed (2.1.1b)

Rear Drive chain sprocket worn to excess (6.2.1e)

Rear Lower Rear suspension bush has excessive free play (2.4.A2a(i))

Front Fairings insecure but not likely to impede the steering (2.1.2e)

Rear Drive chain slightly loose (6.2.1d)

Side stand switch u/s

Front Headlamp aim too low (1.6)

Front Motorcycle structure insecure and likely to affect the correct functioning of the steering or braking (6.1.1c)

Front Tyre worn close to the legal limit (4.1.3(ii))

Front Tyre worn close to the legal limit (4.1.3(ii))

Exhaust noisy (7.1.2)

Nearside Steering control has reduced clearance at full lock not affecting the riders grasp of handlebars (2.1.2b)

Exhaust noise is clearly in excess of that emitted by a similar motor bicycle fitted with a standard silencer in average condition (7.1.2)

Rear Exhaust mounting does not fully support the exhaust system (7.1.1.c)

Rear Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))