2010 Peugeot Boxer

Front Suspension component mounting prescribed area is corroded but not considered excessive inner arches suspension turret corroded both side (5.3.6 (a) (i))

Headlamp lens slightly defective both sides (4.1.1 (b) (i))

Nearside Front Inner Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Registration plate lamp inoperative in the case of a single lamp or all lamps both sidse (4.7.1 (b) (ii))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Front Suspension component mounting prescribed area is corroded but not considered excessive inner arches suspension turret corroded both side (5.3.6 (a) (i))

Headlamp lens slightly defective both sides (4.1.1 (b) (i))

Nearside Front Inner Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Integral body structure is corroded but structural rigidity is not significantly reduced Front both sides inner arches suspension turret corroded (6.1.1 (c) (i))

Front Suspension component mounting prescribed area is corroded but not considered excessive inner wheel arch both sides by strut mounts (5.3.6 (a) (i))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Exhaust emissions test not completed because smoke levels are significantly in excess of the specified limit values (8.2.2.2 (f))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Headlamp aim unable to be tested (4.1.2 (b))

Offside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Front Suspension component mounting prescribed area is corroded but not considered excessive inner wheel arch both sides by strut mounts (5.3.6 (a) (i))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Nearside Front Lower Suspension arm ball joint likely to become detached (5.3.4 (a) (ii)) DANGEROUS

Offside Front Tyre worn close to legal limit/worn on edge Worn inner edge (5.2.3 (e))

Nearside Front Lower Suspension arm ball joint has slight play (5.3.4 (a) (i))

Offside Front Lower Suspension arm ball joint has slight play (5.3.4 (a) (i))

Trailer electrical socket wiring insulation damaged or deteriorated (4.10 (b) (i))

Exhaust emissions test not completed because smoke levels are significantly in excess of the specified limit values (8.2.2.2 (f))

Offside Headlamp aim not tested (4.1.2 (b))

Offside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Registration plate lamp inoperative in the case of a single lamp or all lamps both sides (4.7.1 (b) (ii))

Windscreen washer provides insufficient washer liquid (3.5 (a))

Nearside Front Lower Suspension arm ball joint has slight play (5.3.4 (a) (i))

Offside Front Lower Suspension arm ball joint has slight play (5.3.4 (a) (i))

Trailer electrical socket wiring insulation damaged or deteriorated (4.10 (b) (i))

Offside Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Exhaust emissions test not completed because smoke levels are significantly in excess of the specified limit values (8.2.2.2 (f))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Towball/hitch not fitted at time of test ()