2008 Ford Ka

Nearside Stop lamp(s) not working (4.3.1 (a) (ii))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Front Subframe mounting prescribed area excessively corroded significantly reducing structural strength n/s & o/s floor areas (marked) (5.3.6 (a) (i))

Nearside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced top seat belt mounting. (corrosion is around the fuel filler area) (7.1.1 (a) (i))

Nearside Seat belt anchorage prescribed area strength or continuity significantly reduced outer sill (7.1.1 (a) (i))

Nearside Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Front Lower Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Front Suspension arm pin or bush excessively worn lower arm rear bush (5.3.4 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill and into inner wheel arch area (5.3.6 (a) (i))

Exhaust has a minor leak of exhaust gases front flexy area (6.1.2 (a))

underbody condition corroded and poor

Nearside Front Brake linkage has restricted free movement (1.1.15 (e))

Nearside Front Coil spring fractured or broken (5.3.1 (b) (i))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

front brake discs poor

Body has slight corrosion all over the car (6.1.B.2)

Offside Front Suspension arm has slight play in a pin/bush bush split out (2.4.G.2)

Offside Rear coil spring corroded (2.4.C.1b)

body condition is poor

Nearside Rear Registration plate lamp not working (1.1.C.1d)

Nearside Rear Sub-frame has excessive play in a pin/bush (2.4.G.2)

Offside Rear Sub-frame has excessive play in a pin/bush (2.4.G.2)

Body has slight corrosion all over the car (6.1.B.2)

Offside Front Suspension arm has slight play in a pin/bush bush split out (2.4.G.2)

Offside Rear coil spring corroded (2.4.C.1b)

body condition is poor

Nearside Front wheel bearing has slight play (2.5.A.3c)

Offside Headlamp not working on dipped beam (1.7.5a)

Rear Exhaust system not adequately supported hanger detached (7.1.1)

Nearside Front wheel bearing has slight play (2.5.A.3c)

Offside Rear Registration plate lamp not working (1.1.C.1d)

Offside Inner Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Road wheel bead rim badly distorted (4.2.A.1a)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)