2007 BMW 525

Front Coil spring corroded Both (5.3.1 (b) (i))

Front Lower Suspension arm pin or bush worn but not resulting in excessive movement Forward Arms Both (5.3.4 (a) (i))

Offside Front Lower Windscreen damaged but not adversely affecting driver's view CHIP (3.2 (a) (i))

Nearside Front Anti-roll bar ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Rear Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt BOTH (6.1.7 (g) (ii))

Offside Rear Inner Tyre has a bulge, caused by separation or partial failure of its structure Side Wall (5.2.3 (d) (ii)) DANGEROUS

Front Coil spring corroded Both (5.3.1 (b) (i))

Front Lower Suspension arm pin or bush worn but not resulting in excessive movement Forward Arms Both (5.3.4 (a) (i))

Offside Front Lower Windscreen damaged but not adversely affecting driver's view CHIP (3.2 (a) (i))

Offside Rear Inner Tyre has a cut but not deep enough to reach the ply or cords Side Wall (5.2.3 (d) (i))

Nearside Rear Tyre has a cut but not deep enough to reach the ply or cords Inner edge (5.2.3 (d) (i))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Offside Front Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Nearside Rear Tyre has a cut but not deep enough to reach the ply or cords Inner edge (5.2.3 (d) (i))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Rear tyre slight uneven wear

Nearside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Offside Rear Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

engine cover and under tray fitted

Engine covers fitted obscuring some components in the engine bay

Under-trays fitted obscuring some underside components

Engine covers fitted obscuring some components in the engine bay

Under-trays fitted obscuring some underside components

Tyre tread depth below requirements of 1.6mm (4.1.E.1)