1994 Rover 216

Nearside Front constant velocity joint gaiter split (2.5.C.1a)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear Trailing arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Trailing arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

front brake pads getting low

near side outer sill starting to corrode.

off side rear trailing arm bush starting to split.

repair to o/s rear door sill heavily undersealed making accurate judgement of weld quality impossible.

windscreen cracked on off side slightly.

Nearside Front constant velocity joint gaiter split (2.5.C.1a)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Seat belt anchorage prescribed area is excessively corroded (5.2.6)

front brake pads getting low

near side outer sill starting to corrode.

off side rear trailing arm bush starting to split.

windscreen cracked on off side slightly.

Centre exhaust section in poor condition at welded joints

Front Brake pad(s) wearing thin (3.5.1g)

Minor leak on welded joint on centre section of exhaust.

Nearside Front Lower Anti-roll bar linkage rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Nearside Outer Front constant velocity joint gaiter split (2.5.C.1a)

Centre exhaust section in poor condition at welded joints

Front Brake pad(s) wearing thin (3.5.1g)

Minor leak on welded joint on centre section of exhaust.

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Direction indicator incorrect colour (1.4.A.2f)

Steering wheel retaining device insecure (2.1.6)

brake fluid low

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Rear Suspension arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Offside Front Anti-roll bar linkage rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

Offside Front Front constant velocity joint gaiter split (2.5.C.1a)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)