2000 Toyota Celica

Exhaust catalytic converter missing where one was fitted as standard (7.1.3)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Exhaust has a major leak of exhaust gases (7.1.2)

Exhaust system not adequately supported (7.1.1)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Exhaust noisy (7.1.4)

Nearside Rear Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

both front tyres wearing on inner edges

Exhaust has a minor leak of exhaust gases (7.1.2)

Exhaust noisy (7.1.4)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Headlamp deteriorated but light output not reduced (1.7.5a)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Headlamp deteriorated but light output not reduced (1.7.5a)

Parking brake lever has little reserve travel (3.1.6b)

Play in steering rack inner joint(s)

all rear anti-roll bar bushes worn

both sides rear tyres worn on inner edges

front and rear suspension damping effect reduced

nearside door bottom corroded

nearside wiper blade deteriorated

offside rear tyre has cut in sidewall2

slight play in all front anti-roll bar bushes

vehicle lowerd at time of test

Nearside Front wheel bearing has excessive play (2.5.A.3c)

Offside Front wheel bearing has excessive play (2.5.A.3c)

Offside Registration plate lamp not working (1.1.C.1d)

Rear fog lamp not working (1.3.2b)

Rear fog lamp tell tale not working (1.3.1b)

Parking brake lever has little reserve travel (3.1.6b)

all rear anti-roll bar bushes have slight play

both rear tyres worn on inner edges

exhaust has a minor leak of exhaust gasses

exhaust noisey

nearside door corroded

offside rear tyre has a cut in sidewall

Front registration plate deteriorated but not likely to be misread (6.3.1d)

Rear Anti-roll bar rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Bonnet cannot be secured in the closed position (8.4.1)

Nearside Front Tyre has ply or cords exposed (4.1.D.1b)

Offside Front Tyre has ply or cords exposed (4.1.D.1b)

Rear fog lamp tell tale not working (1.3.1b)

Front registration plate deteriorated but not likely to be misread (6.3.1d)

Rear Anti-roll bar rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front suspension has a suspension upper ball joint securing nut not locked (2.5.B.1a)

Suspension weakened but no possibility of the body or a component fouling a road wheel (2.4.A.1b)

offside front track rod end split pin missing

Offside Front Front position lamp(s) not working (1.1.A.3b)

Handbrake lever reaching limits of travel

Rear brake disc surfaces in poor condition

Rear brake disc surfaces poor

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

front pads 80% worn

Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Front Front constant velocity joint gaiter split (2.5.C.1a)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre has ply or cords exposed (4.1.D.1b) DANGEROUS

front pads 80% worn