2005 Mitsubishi L200 Double Cab

underside undersealed

underside coated in underseal

Rear Rear reflector missing (4.8.2 (a) (ii))

underside coated in underseal

Oil leak, but not excessive (8.4.1 (a) (i))

UNDERSIDE HAS LIGHT SURFACE CORROTION

UNDERSIDE IN A MUDDY CONDITION

underside has light corrotion

underside in a muddy condition

Both front brake calipers close to wheels

Brake pipe corroded, covered in grease or other material Both front rear pipes (1.1.11 (c))

Oil leak, but not excessive (8.4.1 (a) (i))

Suspension arm pin or bush worn but not resulting in excessive movement All front offside and nearside bushes (5.3.4 (a) (i))

Brake pipe excessively corroded all rear brake pipes (1.1.11 (c))

Brake pipe excessively corroded on both front brake calipers (1.1.11 (c))

Central Prop shaft bearing excessively worn (6.1.7 (b) (i))

Emissions not tested can not put probe into exhaust the exhaust is higher than the cab (8.2.2.2 (e))

Exhaust gas recirculation valve missing where one was fitted as standard (8.2.2.1 (a))

Exhaust has a major leak of exhaust gases (6.1.2 (a))

Exhaust noise is clearly in excess of that emitted by a similar vehicle fitted with a standard silencer in average condition (8.1.1 (a))

Horn sound not in accordance with requirements (7.7 (c))

Nearside Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt inner (6.1.7 (g) (ii))

Nearside Front Brake hose ferrule excessively corroded (1.1.12 (f) (i))

Nearside Front Brake pipe excessively corroded (1.1.11 (c))

Nearside Headlamp aim too high (4.1.2 (a))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Front Brake hose ferrule excessively corroded (1.1.12 (f) (i))

Offside Front Brake pipe excessively corroded (1.1.11 (c))

Offside Headlamp aim too high (4.1.2 (a))

Offside Rear fog lamp light intensity significantly reduced very small light fitted (4.5.4 (a))

Offside Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Brake pipe corroded, covered in grease or other material front tom rear pipes (1.1.11 (c))

Front Brake pad(s) wearing thin both sides (1.1.13 (a) (ii))

Oil leak, but not excessive (8.4.1 (a) (i))

Suspension arm pin or bush worn but not resulting in excessive movement all front bushes cracked (5.3.4 (a) (i))

both front brake calipers very close to wheels

Unable To Make A Full & Clear Assesment Of Chassis, Structure & Brake Pipes Due To Underseal

Nearside Front Inner Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Power steering component leaking (2.1.5 (a))

Unable To Make A Full & Clear Assesment Of Chassis, Structure & Brake Pipes Due To Underseal

Brake pipe slightly corroded main pipe (3.6.B.2c)

Rear Brake pipe slightly corroded cross (3.6.B.2c)

Front Brake pipe slightly corroded (3.6.B.2c)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Front Brake pipe slightly corroded (3.6.B.2c)

Front Brake pipe slightly corroded (3.6.B.2c)

brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Rear Shock absorber has an excessively worn bush (2.7.4)

Front Brake pipe slightly corroded (3.6.B.2c)

Nearside Front Front wheel bearing has excessive play (2.5.A.3c)

Offside Front Front wheel bearing has excessive play (2.5.A.3c)

brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Brake pipe slightly corroded (3.6.B.2c)

Nearside Front Anti-roll bar has excessive play in a pin/bush (2.4.G.2)

Nearside Front Track rod end ball joint has excessive play (2.2.B.1f)

Offside Front Anti-roll bar has excessive play in a pin/bush (2.4.G.2)

Offside Front position lamp(s) not working (1.1.A.3b)

Nearside Rear Lower Shock absorber has a slightly worn bush (2.7.4)

Offside Rear Lower Shock absorber has a slightly worn bush (2.7.4)

front tyres 4mm but worn on edges