1994 Honda Cbr 600

Nearside Footrest missing (6.2.12 (a))

Rear reflector missing (4.8.2 (a) (ii))

Motorcycle structure slightly corroded (6.1.1a)

Rear Tyre worn close to the legal limit (4.1.3(ii))

Front Floor brake test indicates a sticking brake (3.3.C2c)

Rear Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))

Rear Brake pad(s) close to minimum limit (3.2.A1f(i))

Rear Tyre worn close to the legal limit (4.1.3(ii))

excessive tape around headlamp

Front Headlamp aim headlamp damaged and function impaired (1.2.3a)

Front Headlamp aim too high (1.6)

Nearside Front Handlebar handgrip not secure to handlebars. (2.1.1c)

Nearside Front Upper Front suspension fouling which affects the movement of the front suspension. (2.3.6a)

Rear Brake pedal cannot be applied smoothly (3.1.3d)

Rear Tyre worn close to the legal limit (4.1.3(ii))

Rear Drive chain sprocket slightly worn (6.2.1e)

Front Tyre worn close to the legal limit (4.1.3(ii))

Rear Tyre worn close to the legal limit (4.1.3(ii))

Nearside Front Brake disc(s) cracked (3.2.A1g)

Roller brake test The less effective brake control does not achieve an efficiency of 25%. (3.3.A2b)

Front Brake pad(s) close to minimum limit (3.2.A1f(i))

Front Tyre worn close to the legal limit (4.1.3(ii))

Rear Tyre worn close to the legal limit (4.1.3(ii))

Exhaust mounting does not fully support the exhaust system (7.1.1.c)

Front Brake master cylinder insecurely mounted (3.2.B1a)

Front Front position lamp does not illuminate immediately when switched on (1.1.3a)

Nearside Front Handlebar handgrip not secure to handlebars. (2.1.1c)

Rear Rear position lamp adversely affected by the operation of another lamp (1.1.3b)

Rear Registration plate incorrect (6.3.1a)

Rear Roller brake test indicates a sticking brake (3.3.A1a)

Offside Front Handlebar handgrip not secure to handlebars. (2.1.1c) DANGEROUS

Exhaust noise is clearly in excess of that emitted by a similar motor bicycle fitted with a standard silencer in average condition (7.1.2)

Front Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))

Rear wheel bearings have slight free play (2.4.A.2c)

electrical wiring damaged/contaminated