1993 Nissan Sunny

Body has slight corrosion platted (6.1.B.2)

Brake pipe slightly corroded all (3.6.B.2c)

Exhaust has a minor leak of exhaust gases (7.1.2)

Front Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Front brake disc modified but not seriously weakened (3.5.1n)

Offside Rear Rear position lamp(s) damaged, but still visible from a reasonable distance (1.1.A.3d)

Subframe mounting prescribed area is corroded but not considered excessive all has surface (2.4.A.3)

Subframe mounting prescribed area repaired, but not inappropriately (2.4.A.3)

Suspension arm corroded but not seriously weakened all (2.4.G.1)

Suspension arm rubber bush deteriorated but not resulting in excessive movement all (2.4.G.2)

Vehicle structure has slight corrosion both outer sill platted (6.1.B.2)

Vehicle structure has slight corrosion under side has surface (6.1.B.2)

Nearside Rear Brake pipe excessively corroded (3.6.B.2c)

Offside Rear Outer Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings sill (6.1.B.2)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Rear Suspension component mounting prescribed area is corroded but not considered excessive both at rear platted (2.4.A.3)

Suspension weakened but no possibility of the body or a component fouling a road wheel all has surface corrosion (2.4.A.1b)

Vehicle structure has slight corrosion under-side has surface corrosion due to standing !!!!!!! (6.1.B.2)

Body has slight corrosion (6.1.B.2)

Rear Shock absorber has a light misting of oil (2.7.3)

Battery insecure (1.9.1)

Body has slight corrosion (6.1.B.2)

Front Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside front brake fluctuating, but not excessively (3.7.B.3)

Vehicle structure has slight corrosion (6.1.B.2)

Body has slight corrosion (6.1.B.2)

Front Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Nearside front brake fluctuating, but not excessively (3.7.B.3)

Vehicle structure has slight corrosion (6.1.B.2)

Body has slight corrosion (6.1.B.2)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Rear Brake pipe slightly corroded (3.6.B.2c)

front brake grabbing slightly (3.7.A.2b)

Brake hose excessively deteriorated (3.6.B.4d)

Front position lamp(s) not working (1.1.A.3b)

Nearside Front Mechanical brake component has restricted free movement (3.5.1k)

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front wheel bearing has excessive play (2.5.A.3c)

advise underside at rear corroding

Offside Front Brake hose excessively deteriorated (3.6.B.4d)

Offside Front Brake pipe excessively corroded (3.6.B.2c)

Offside Front Front constant velocity joint gaiter split (2.5.C.1a)

Offside Rear Brake pipe excessively corroded (3.6.B.2c)

Offside Rear Tyre has a lump, caused by separation or partial failure of its structure (4.1.D.1b)

advise underside at rear corroding

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Brake pipe excessively corroded (3.6.B.2c)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Headlamp aim too high (1.8)

underside at rear heavy corrosion forming around suspension and inner sill panels

underside at rear heavy corrosion forming around suspension and inner sill panels

Brake hose ferrule excessively corroded (3.6.B.4e)

Brake pad(s) less than 1.5 mm thick (3.5.1g)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Front constant velocity joint gaiter split (2.5.C.1a)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Mechanical brake component has restricted free movement (3.5.1k)

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

brake disc excessively scored (3.5.1h)

front brake application uneven (3.7.B.2)

Brakes imbalanced across an axle (3.7.B.5b) DANGEROUS

Exhaust has part of the system slightly deteriorated (7.1.1a)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Front Tyre worn close to the legal limit (4.1.E.1)