2000 Toyota MR2

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Exhaust has a major leak of exhaust gases (6.1.2 (a))

Horn not working (7.7 (a) (ii))

Nearside Front Service brake binding but not excessively (1.2.1 (f))

Nearside Front Suspension arm ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

rear back plate missing

Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Front Suspension arm ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Parking brake lever has no reserve travel (3.1.6b)

rear back plate missing

Emissions not tested due to exhaust leak (7.3.A.1)

Front Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Front Brake hose excessively damaged (3.6.B.4d)

Parking brake lever has no reserve travel (3.1.6b)

Nearside Front Suspension arm ball joint dust cover damaged, but preventing the ingress of dirt (2.4.G.2)

Nearside front brake binding (3.7.B.1)

Nearside Front Anti-roll bar linkage ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Nearside Rear Brake hose has insufficient room to move, resulting in fouling on any part (3.6.B.4a)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear Suspension component mounting prescribed area is inadequately repaired (2.4.A.3)

Offside Front Anti-roll bar linkage ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Rear Brake hose has insufficient room to move, resulting in fouling on any part (3.6.B.4a)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is inadequately repaired (2.4.A.3)

Parking brake lever has no reserve travel (3.1.6b)

Parking brake: efficiency below requirements (3.7.B.7)

Passenger's seat insecure (6.2.A.1)

STRONG ADVISE - PLAY AND NOISE WHEN SHAKING WHEELS TOP TO BOTTOM

STRONG ADVISE - WIPERS POOR AT CLEARING SCREEN

all brake hoses cable tied to suspension in mounting points ( secure at present )

battery went flat during mot test

coolant pipe poorly touching intake pipe

corrosion throughout underside and in inner wheel arches / spring mounting area

front indicators faded

front number plate starting to deteriorate

fuel filler pipes corroded

kick in both handbrake quadrants in calipers

n/s sill slightly damaged and corroded

o/s rear back plate missing

play in o/s rear shock and very slight play in n/s rear shock

pulse in rear brakes , slight pulse in front brakes

radiator/ condensor and fan housing in poor condition

rear body strut bars corroded and holed

rear discs in poor condition

slight play and kick in steering

small exhaust blows evident ( poorly repaired/welded)

Fuel pipe/s corroded

Offside Rear Anti-roll bar rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

brake pipes starting to corrode throughout vehicle

new suspension legs fitted all round brake hoses mounted close to mounting bolts

offside rear wheel has been repaired

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Fuel pipe/s corroded

Offside Rear Anti-roll bar rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

brake pipes starting to corrode throughout vehicle

new suspension legs fitted all round brake hoses mounted close to mounting bolts

offside rear wheel has been repaired

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Exhaust emissions hydrocarbon content after 2nd fast idle excessive (7.3.D.3)

Front Coil spring not correctly located (2.4.C.2)

Front Exhaust has a major leak of exhaust gases (7.1.2)

Horn not working (1.6.2a)

Nearside Headlamp aim too high (1.8)

Offside Front Shock absorber has a serious fluid leak (2.7.3)

Offside Front Tyre fouling a part of the vehicle (4.1.D.2)

Offside Windscreen wiper not operating over a large enough area to give an adequate view (8.2.1c)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

Wheel nut(s) missing (4.2.A.1e)

Windscreen has damage to an area in excess of a 10mm circle within zone 'A' (8.3.1a)

Windscreen has damage to the swept area in excess of a 40mm circle outside zone 'A' (8.3.1d)

Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Road wheel badly damaged (4.2.A.1a) DANGEROUS

Parking brake lever has no reserve travel (3.1.6b) DANGEROUS

Fuel pipe/s corroded

Offside Rear Anti-roll bar rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

brake pipes starting to corrode throughout vehicle

Offside Front Braking system leaking (3.6.A.1)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Vehicle structure has slight corrosion (6.1.A.1)

front and rear suspension corroded

o/s/r suspension has slight play

support brkts corroded and bolt loose on o/s

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside front brake binding (3.7.B.1)

Parking brake lever has no reserve travel (3.1.6b)

Windscreen has a sticker or other obstruction encroaching into the swept area by more than 40mm outside zone 'A' (8.3.1e)

Vehicle structure has slight corrosion (6.1.A.1)

front and rear suspension corroded

o/s/r suspension has slight play

support brkts corroded and bolt loose on o/s

brake pipes covered with plastic covers

corrosion underbody

Front Windscreen has a sticker or other obstruction encroaching by more than 10mm within zone 'A' (8.3.1b)

nearside front brake slightly binding

play in nearside rear wheel bearing

nearside front brake slightly binding

play in nearside rear wheel bearing

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Macpherson strut upper support bearing is rough in operation (2.5.B.1b)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Headlamp aim too high when the centre of the headlamp is below 850mm from the ground (1.6.B2)

Offside Rear wheel bearing has excessive play (2.6.2)

Rear fog lamp tell tale not working (1.3.1b)

Front Brake pad(s) wearing thin (3.5.1g)

Front brake disc slightly scored (3.5.1h)