1994 Rover Mini

Offside Front Seat belt anchorage prescribed area is inadequately repaired central sill (7.1.1 (a) (i))

Electrical wiring insulation so damaged or deteriorated it is likely to cause a short-circuit in boot ,,in side vehicle and under bonnet (4.11 (c) (ii))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Front Bumper damaged and likely to cause injury when grazed or contacted bumper missing leaving sharp edges (6.1.4 (a) (i))

Front Subframe mounting prescribed area excessively corroded significantly reducing structural strength corrosion with 30 cms of rear mountings (5.3.6 (a) (i))

Nearside Front Suspension component ball joint dust cover no longer prevents the ingress of dirt trunion dust cover not secured (5.3.4 (b) (ii))

Nearside Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Front Suspension component ball joint dust cover no longer prevents the ingress of dirt trunion dust cover not secured (5.3.4 (b) (ii))

Offside Headlamp aim too low (4.1.2 (a))

Steering wheel rim loose (2.2.1 (c) (i))

Brake pipe inadequately clipped or supported front to ridged pipe not clipped fully to all clips (1.1.11 (d) (i))

Nearside Front Wheel bearing has slight play (5.1.3 (a) (i))

corrosion to various areas or sills and floor

Brake pipe excessively corroded front to rear metal (3.6.B.2c)

Front Exhaust has a major leak of exhaust gases joints (7.1.2)

Front Exhaust system not adequately supported joint (7.1.1)

Nearside Front Brake pipe excessively corroded (3.6.B.2c)

Nearside Front Sub-frame attachment bracket/mounting insecure (2.4.G.1)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Rear Subframe mounting prescribed area is excessively corroded rear mounting area (2.4.A.3)

Nearside Upper Front suspension has excessive play in a upper suspension ball joint (2.5.B.1a)

Offside Rear Direction indicator not working (1.4.A.2c)

Offside Rear Subframe mounting prescribed area is excessively corroded rear mounting area (2.4.A.3)

Offside Windscreen washer provides insufficient washer liquid (8.2.3)

front floors corroded

nearside outersill corroded heavily

nearside outersill rusted through by jacking point, outside prescribed areas

oil around engine

weld repairs to offside outersill heavily undersealed

Front Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Front Tie bar/rod slightly distorted (2.4.G.1)

Offside Steering rack gaiter deteriorated (2.2.D.2d)

Rear Rear fog lamp slightly discoloured (1.3.2e)

Nearside Front Front position lamp(s) not working (1.1.A.3b)

Nearside Front Headlamp not working on dipped beam (1.7.5a)

Nearside Front Headlamp not working on main beam (1.7.5a)

Offside Front Front position lamp(s) not working (1.1.A.3b)

Offside Front Headlamp not working on dipped beam (1.7.5a)

Offside Front Headlamp not working on main beam (1.7.5a)

Corrosion n/s/f sill(holed)

Corrosion o/o/f wing

Corrosion o/s/f sill

Nearside Rear Sub-frame corroded but not seriously weakened (2.4.G.1)

Offside Rear Sub-frame corroded but not seriously weakened (2.4.G.1)

Rear Brake pipe slightly corroded (3.6.B.2c)

Rear Sub-frame corroded but not seriously weakened (2.4.G.1)

corrosion both outer seals

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Rear Sub-frame corroded but not seriously weakened (2.4.G.1)

corrosion both outer seals