1994 Citroen C15

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Suspension component ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Front Suspension component ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Front Seat belt anchorage prescribed area strength or continuity significantly reduced Floor Underneath (7.1.1 (a) (i))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Inner/Outer Sill (5.3.6 (a) (i))

Offside Front Direction indicator not working (4.4.1 (a) (ii))

Offside Front Seat belt anchorage prescribed area strength or continuity significantly reduced Door Jam/Sill (7.1.1 (a) (i))

Offside Headlamp aim too low (4.1.2 (a))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Inner/Outer Sill (5.3.6 (a) (i))

Offside Side repeater not working (4.4.1 (a) (ii))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Central Rear Vehicle structure is corroded but structural rigidity is not significantly reduced Chassis Rail (6.1.1 (c) (i))

Indicator switch faulty (4.4.2 (a) (i))

Nearside Front Vehicle structure is corroded but structural rigidity is not significantly reduced Inner Arch/Chassis Rail (6.1.1 (c) (i))

Offside Track rod end ball joint has slight play (2.1.3 (b) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Radiator Support Corroded

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Nearside Front Outer Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Rear Tyre slightly damaged/cracking or perishing both (5.2.3 (d) (ii))

Battery insecure and likely to cause a short circuit (4.13 (a) (ii))

Nearside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Front Headlamp insecure (4.1.1 (c))

Nearside Front Headlamp levelling device inoperative (4.1.5 (a))

Nearside Front Seat belt anchorage prescribed area strength or continuity significantly reduced floor pan (7.1.1 (a) (i))

Nearside Rear Service brake lagging in operation (1.2.1 (d))

Offside Front Headlamp aim too high (4.1.2 (a))

Offside Front Headlamp insecure (4.1.1 (c))

Offside Front Headlamp levelling device inoperative (4.1.5 (a))

Offside Front Seat belt anchorage prescribed area strength or continuity significantly reduced inner and outer sil pannels (7.1.1 (a) (i))

Offside Front Service brake lagging in operation (1.2.1 (d))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Offside Rear Subframe mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected sil panel inner an outer (5.3.6 (a) (ii)) DANGEROUS

Nearside Front Outer Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security corner of chassis (6.2.2 (d) (i))

Offside Front Service brake binding but not excessively (1.2.1 (f))

Offside Rear Tyre slightly damaged/cracking or perishing excessive cracking (5.2.3 (d) (ii))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Headlamp insecure (1.7.3)

Nearside Side repeater not working (1.4.A.2c)

Offside Front Outer Seat belt anchorage prescribed area is excessively corroded sill (5.2.6)

Offside Headlamp aim too high (1.8)

Front Suspension component mounting prescribed area is corroded but not considered excessive cross member weak (2.4.A.3)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Fuel Pipe/s corroded ()

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Suspension component mounting prescribed area is corroded but not considered excessive both outer sills (2.4.A.3)

Battery insecure (1.9.1)

Brake pedal spongy (3.3.B.1b)

Nearside Side repeater not working (1.4.A.2c)

Offside Rear Suspension component mounting prescribed area is excessively corroded chassie leg / cross member (2.4.A.3)

Parking brake lever has no reserve travel (3.1.6b)

Parking brake: efficiency below requirements (3.7.B.7)

Service brake: efficiency below requirements (3.7.B.7)

Windscreen washer provides insufficient washer liquid (8.2.3)

Rear rear brake recording little or no effort (3.7.B.5a) DANGEROUS

rear parking brake recording little or no effort (3.7.B.6a) DANGEROUS

Front Suspension component mounting prescribed area is corroded but not considered excessive cross member weak (2.4.A.3)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Fuel Pipe/s corroded ()

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Suspension component mounting prescribed area is corroded but not considered excessive both outer sills (2.4.A.3)

Exhaust has a minor leak of exhaust gases (7.1.2)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

fuel pipes corroded

offside rear tyre low on inside edge

rear crossmembers corroded

Brake master cylinder/servo mounting prescribed area is excessively corroded front baulkhead area (3.6.C.3)

Nearside Headlamp aim beam image kick up to the offside (1.8)

Nearside Rear Suspension component mounting prescribed area is excessively corroded undersill area (2.4.A.3)

Nearside Side repeater not working (1.4.A.2c)

Offside Front wheel bearing rough when rotated (2.5.A.2)

Offside Headlamp aim too high (1.8)

Rear Brake valve leaking (3.6.A.1)

Seat belt anchorage prescribed area is excessively corroded front floor both sides (5.2.6)

Exhaust has a minor leak of exhaust gases (7.1.2)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

fuel pipes corroded

offside rear tyre low on inside edge

rear crossmembers corroded

Brakes imbalanced across an axle (3.7.B.5b)

Nearside Front Suspension arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Nearside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Nearside Headlamp insecure (1.7.3)

Offside Front Suspension arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Offside Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside rear brake recording little or no effort (3.7.B.5a)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Service brake: efficiency below requirements (3.7.B.7)

Exhaust has a minor leak of exhaust gases (7.1.2)

Fuel pipe/s corroded

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Hazard warning switch faulty (1.4.B.1d)

Nearside Headlamp aim too low (1.8)

Nearside Headlamp insecure (1.7.3)

Offside Headlamp aim too low (1.8)

Offside Headlamp insecure (1.7.3)

Coolant leak

Fuel pipe/s corroded

Front Brake hose slightly deteriorated (3.6.B.4d)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Front registration plate character(s) not correctly formed (6.3.4b)

Nearside Front Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Front Brake hose slightly deteriorated (3.6.B.4d)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Front anti roll bar bushes are starting to deteriorate.

Front number plate is deteriorating.

No spare tyre under car.

Front number plate is cracked.

N/s inner driveshaft gaiter is split.

Offside Side repeater not working (1.4.A.2c)

Sills are starting to corrode.

Front number plate is cracked.

N/s inner driveshaft gaiter is split.

Sills are starting to corrode.

Both front brake hoses slightly perished

Both front compliance bushes perished

Both outer lower sills corroded

Brake fluid level close to minimum

Rear brake compensator valve wet.

Rear exhaust mount rubbers heavily perished

Rearview mirror missing

Headlamp aim not tested (1.8.A.1c)

Nearside Front Side repeater not working (1.4.A.2c)

Nearside Headlamp insecure (1.7.3)

Offside Front Side repeater not working (1.4.A.2c)

Offside Headlamp not working on dipped beam (1.7.5a)

Offside Headlamp not working on main beam (1.7.5a)

rear brake application uneven (3.7.B.2)

Both front brake hoses slightly perished

Both front compliance bushes perished

Both outer lower sills corroded

Brake fluid level close to minimum

Rear brake compensator valve wet.

Rear exhaust mount rubbers heavily perished

Rearview mirror missing

Nearside Inner Front constant velocity joint gaiter deteriorated (2.5.C.1a)

n/s headlamp in poor condition

o/s outer sill corroded

o/s/f tyre perished

Nearside Inner Front constant velocity joint gaiter deteriorated (2.5.C.1a)

Offside Outer Seat belt anchorage prescribed area is corroded but not considered excessive (5.2.6)

imbalance on rear brakes

Nearside Front Front constant velocity joint gaiter split (2.5.C.1a)

Nearside Front Side repeater not working (1.4.A.2c)

Nearside Headlamp aim too high when the centre of the headlamp is below 850mm from the ground (1.6.B2)

Nearside Stop lamp not working (1.2.1b)

Offside Headlamp not working on dipped beam (1.7.5a)

Rear Registration plate lamp not working (1.1.5c)

corrosion on bulkhead seam